Pioneer PDK-50HW3 specifications Installing and Using Software

Page 39

4. Installing and Using Software

2.When all components of test board D (LED) and all components of test board K (Sens) are malfunctioning. The detailed list indicates “ALL” and not data for each Point.

Note:

“ALL” may indicate a malfunction that is not caused by the specific board. Control signal lines from the test board A (LED) and optical signals lines to the test board A (LED) are relayed via other boards so a malfunction could be caused by defective connectors on boards in this chain.

3. When some components of test board A (LED) and all test board H (Sens) components are malfunctioning “Check” is indicated when some components are malfunctioning.

The test address number and assessment for all related LED and Sens appear in the detailed list.

Note:

The handwriting device must be reset (disconnect and connect USB cable) to switch DIP switch to service mode.

39

Image 39
Contents Technical Manual Ver New design Pioneer badge need no longer be removed during installationChanges from PDK-50HW2A to PDK-50HW3 Scan device changesFlash pattern of the power indicator has changed Location of the PEN-NORMAL mode selector switch has changedUSB cable clip location Pen stand has been modified Pen stand modificationsChanges made to the pen Changes in the driverChanges in service Service Mode has been improvedMiddle button 3-button emulation is supported Contents Separate plasma display PDP-504CMX specifications SpecificationsSpecifications System plasma display and handwriting device specificationsAccessories Plasma display monitor PDP-504CMX/PDP-50MXE1/PDP-50MXE1-SHandwriting device PDK-50HW3 Outline Drawing External dimension drawingPDK-50HW3 center line USB cable exit Plasma displaySide panel PDK-50HW3 as seen from rear¶ Name and function of parts ¶ External dimension drawingConfirming Battery Life Name and Function of Parts & Pin LayoutList showing compatibility of standard metal fittings Installation SiteInstallation Site Installation ConditionsSpecial installations Ultrasonic waves Installation precautionsInstallation of multiple systems Exposure to direct sunlightUnpacking Installation ProceduresTransportation precautions Installing the handwriting device PDK-50HW3 Assembly and ConnectionsBattery cover Changing the pen batteryCheck Computer Setup ExampleConnecting the plasma display to a computer Precautions regarding computer setupProcedures for setting the plasma display Adjusting the Plasma DisplayInstalling the Driver Connecting a Scan Device to a ComputerScreen burning Check in PEN mode How to Use Cable ClipCheck in Service Mode Check in Normal mode¶ Alignment of pen tip and cursor position Final Check Operating environment Installing and Using SoftwareInstalling the CBdrvU Ver .0 Driver Installation proceduresCBdrvU operations Using the DriverUninstall procedures Changes from CBdrv Ver .4 to CBdrvU VerHot key operations Scan device setup screen Select Calibration dialogScan device off screen Calibration Detail-1 OK buttonCalibration Detail-2 Easy SettingDouble-click area Property screenDouble-click speed Other setupTest Mode Test chart displayState display Disabling CBdrvU Disabling CBdrvUAbout CBdrvU ExitRotate CBdrvU operationTask tray display Precautions Installing and Using Software Status displayed after pressing SelfTest button Using Driver and Service ModeService Mode display Screen itemsInstalling and Using Software Name Part Number Maintenance and CleaningReadjustment of White Balance ScreenReplacing the pen tip Pen battery lifeInternal DIP Switch Settings To lock device in the Normal modeTo make waveform observations Hardware-Related Q&A Page Driver Software-Related Q&A Page Troubleshooting Problem Possible SolutionPlasma Display PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S Error messege Remedy TroubleshootingHandwriting Device PDK-50HW3 Symptom Cause SolutionCapabilities of the Handwriting Device ResolutionLow scan mode High scan mode