1. Specifications
1.4 Name and Function of Parts & Pin Layout
1.4.1 Plasma display monitor (PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S)
For information on the plasma display, refer to “Name and Function of Parts” in the Technical Manual supplied with the
1.4.2 Handwriting device (PDK-50HW3)
a) Scan device
PEN
NORMAL
IR transmitting filter
Power indicator
(Lights green when ON)
Mode selector switch
Set the mode switch in accordance with whether you will use the special pen or other device to input characters and lines on the screen.
PEN Mode:
In this mode, the special accessory
pen can be used to write on the screen. Using the special pen allows the drawing
Rear side | of more clearly delineated characters and | |
of unit | ||
lines. | ||
| ||
| NORMAL Mode: | |
| In this mode, your | |
| finger or other | |
| object can be used to write on the screen. | |
| This mode will produce lower screen | |
| definition, however, compared to drawing | |
| with the dedicated input pen. |
Note:
When the power switch is first turned on, the power indicator will flash orange; while the indicator is flashing, do not touch the screen, since the unit is initializing its internal settings
b) Special pen
¶Name and function of parts
| Holes in rear end of pen |
| LED indicator |
Tip |
|
Cap | Battery cover |
| Large button |
| (corresponds to right |
| mouse button) |
Small button
(The function corresponding to middle mouse button can be assigned using the driver software.)
Pen tip
(corresponds to left mouse button)
¶External dimension drawing
186
If pen operation becomes difficult:
The pen may fail to operate properly if the holes in rear end of pen are blocked. Also, the pen may begin operating erratically when the battery becomes depleted. In this event, change the battery at your earliest opportunity.
Confirming Battery Life:
When the small button is depressed fully, an LED indicator will light. If the indicator fails to light, or lights only dimly, the battery is depleted and should be replaced.
ø18.5
11