Pioneer PDK-50HW3 specifications Calibration Detail-2, Easy Setting

Page 30

4. Installing and Using Software

b) Calibration (Detail-2)

When the plasma display is in the “PARTIAL” mode, use the mouse to click the two points, the upper and lower points to calibrate.

Follow the on-screen calibration instructions and touch the points in the upper and lower half of the screen.

Notes:

¶Use the mouse to make settings in this screen.

¶The set calibration is stored and is available atsubsequent startups.

¶Although the brightness of the screen drops during calibration using Detail-2, it is still possible to verify the display position and adjust the plasma display.

c) Easy Setting

Press the assigned hot keys to set the preset values for the screen modes that are available at current resolution. The name of the screen mode being adjusted appears at the center of the screen as shown below but disappears automatically after setup.

“FULL”, “4:3” and “DOT BY DOT” modes can be set.

Image 30

Contents Technical Manual Ver Scan device changes Pioneer badge need no longer be removed during installationChanges from PDK-50HW2A to PDK-50HW3 New designFlash pattern of the power indicator has changed Location of the PEN-NORMAL mode selector switch has changedUSB cable clip location Changes in the driver Pen stand modificationsChanges made to the pen Pen stand has been modifiedChanges in service Service Mode has been improvedMiddle button 3-button emulation is supported Contents System plasma display and handwriting device specifications SpecificationsSpecifications Separate plasma display PDP-504CMX specificationsAccessories Plasma display monitor PDP-504CMX/PDP-50MXE1/PDP-50MXE1-SHandwriting device PDK-50HW3 External dimension drawing Outline DrawingPDK-50HW3 as seen from rear Plasma displaySide panel PDK-50HW3 center line USB cable exitName and Function of Parts & Pin Layout ¶ External dimension drawingConfirming Battery Life ¶ Name and function of partsInstallation Conditions Installation SiteInstallation Site List showing compatibility of standard metal fittingsSpecial installations Exposure to direct sunlight Installation precautionsInstallation of multiple systems Ultrasonic wavesInstallation Procedures UnpackingTransportation precautions Assembly and Connections Installing the handwriting device PDK-50HW3Changing the pen battery Battery coverPrecautions regarding computer setup Computer Setup ExampleConnecting the plasma display to a computer CheckAdjusting the Plasma Display Procedures for setting the plasma displayInstalling the Driver Connecting a Scan Device to a ComputerScreen burning Check in Normal mode How to Use Cable ClipCheck in Service Mode Check in PEN mode¶ Alignment of pen tip and cursor position Final Check Installation procedures Installing and Using SoftwareInstalling the CBdrvU Ver .0 Driver Operating environmentChanges from CBdrv Ver .4 to CBdrvU Ver Using the DriverUninstall procedures CBdrvU operationsHot key operations Scan device setup screen Select Calibration dialogScan device off screen OK button Calibration Detail-1Easy Setting Calibration Detail-2Property screen Double-click areaOther setup Double-click speedTest Mode Test chart displayState display Exit Disabling CBdrvUAbout CBdrvU Disabling CBdrvURotate CBdrvU operationTask tray display Precautions Installing and Using Software Screen items Using Driver and Service ModeService Mode display Status displayed after pressing SelfTest buttonInstalling and Using Software Screen Maintenance and CleaningReadjustment of White Balance Name Part NumberPen battery life Replacing the pen tipInternal DIP Switch Settings To lock device in the Normal modeTo make waveform observations Hardware-Related Q&A Page Driver Software-Related Q&A Page Troubleshooting Problem Possible SolutionPlasma Display PDP-504CMX/PDP-50MXE1/PDP-50MXE1-S Troubleshooting Error messege RemedySymptom Cause Solution Handwriting Device PDK-50HW3High scan mode ResolutionLow scan mode Capabilities of the Handwriting Device