FujiFilm FinePix S1 owner manual SET-UP Menu Part 1 Specifying a Custom WB Setting

Press the “MENU/EXE” button.

SET-UP Menu Part 1 Specifying a Custom WB Setting

■Use the procedure below to specify a custom white balance setting.

1

2 Press “a” or “b” on the 4-direction button to select “CUSTOM WB” and then press the “MENU/EXE” button or “d” or “c” on the 4-direction button.

•The “SET OK?” message appears on the color LCD monitor.

•Set the focus mode selector switch to “M” (manual focus)☞( P.58).

3	Photograph a reference white image, such as a sheet of
	white paper, that occupies an area larger than the

center-weighted metering area (☞P.15). A message then appears indicating whether the photographed image is valid.

•If the photographed image is not valid, respond to the message displayed as follows:

: The subject is too bright. Apply exposure compensation in the negative (–) direction, select a darker subject or reduce the light level. Then repeat the procedure from step 3.

: The subject is too dark. Apply exposure compensation in the positive (+) direction, select a brighter subject or increase the light level. Then repeat the procedure from step 3.

: The image exceeds the compensation range for the custom WB setting. The maximum compensation value is set. To reset the value, press the “CANCEL” button and repeat the procedure from step 3.

•The color temperature range within which the white balance can be matched is approximately 2800K to 9500K.

4	When the photographed image is valid (when	is
	displayed), press the “MENU/EXE” button.
	If the image is not valid, use one of the solutions given
	in step 3.
	• To cancel the setting procedure, press the “CANCEL” button.
5	When you have finished setting the custom white
	balance, use “a” or “b” on the 4-direction button to

select “END” and then press the “MENU/EXE” button.

50