Warning Displays

If a warning is displayed or flashes in the top display panel, viewfinder display, rear display panel or color LCD monitor, check the points described in the table below before requesting repairs.

Problem

Cause

Solution

Ref.

 

Top display panel

Viewfinder display

 

 

Page

 

 

 

The aperture ring on

Set the aperture ring

P.20

 

à

à

the lens is not set to

on the lens to the

 

 

(flashing)

(flashing)

the narrowest

narrowest aperture.

 

 

 

 

aperture.

 

 

 

 

 

 

 

 

 

O

 

The lithium batteries

Replace the lithium

P.17, 18

 

(flashing)

 

are flat.

batteries.

P.22

 

 

 

 

 

 

 

O

 

The lithium battery

Have spare lithium

P.22

 

(lit)

 

charge is low.

batteries ready.

 

 

 

 

 

 

 

 

 

 

The lens mounted is

Use a Nikkor lens with

P.20

 

¡

¡

not a Nikkor lens with

built-in CPU (excluding

P.106

 

built-in CPU or no lens

IX Nikkor lenses).

 

 

(flashing)

(flashing)

 

 

is mounted on the

(Note that pictures can

 

 

(lit in M mode)

(lit in M mode)

 

 

camera.

still be taken in M

 

 

 

 

 

mode.)

 

 

 

 

 

 

 

 

Ü

 

The slot cover was

Switch the camera off,

P.25

 

 

opened during card

close the slot cover,

P.112

 

(lit)

 

operation.

switch the camera

 

 

 

 

 

back on and try again.

 

 

 

 

 

 

 

 

 

 

• The AA-size batteries

Switch the camera off

P.18

 

 

 

are low on charge or

and replace the AA-

 

 

 

 

flat.

size batteries or load

 

 

Ü

 

• No AA-size batteries

new AA-size batteries.

 

 

(lit)

 

are loaded.

Then switch the

 

 

 

 

 

camera back on and

 

 

 

 

 

try again.

 

 

 

 

 

 

 

 

 

 

The lithium batteries

Switch the camera off

P.17, 18

 

 

 

are low on charge or

and replace the lithium

 

 

 

 

the camera

batteries. Then switch

 

 

 

 

mechanism has

the camera back on

 

 

 

 

stopped due to cold

and try again.

 

 

Ü

 

and cannot take

If this does not resolve

 

 

 

pictures.

the problem, set the

 

 

(flashing)

 

 

 

 

 

focusing mode to M,

 

 

 

 

 

 

 

 

 

 

release the shutter and

 

 

 

 

 

briefly switch the

 

 

 

 

 

camera off.

 

 

 

 

 

 

 

5

 

 

 

 

 

121

Page 121
Image 121
FujiFilm FinePix S1 owner manual 121, Problem Cause Solution