Panasonic WJ-HD500B manual Connection with the DVD Extension Unit with HDD, Copy WJ-HDE510B EXT

<Connection with the DVD Extension Unit with HDD>

The figure shows the WJ-HDE510B with an HDD.

The DVD-RAM is used for backup of the data recorded on the WJ-HD500B Digital Disk Recorder as well as for storing the data of the extension hard disk drive units in the system.

1.Connect between the COPY port on the WJ-HD500B and the COPY IN port on the 1st DVD Extension Unit with the supplied (WJ-HDE510) SCSI cable.

Plug the cable end with magnetic core into the COPY port, and the other ends into the COPY IN port.

2.Connect between the EXT STORAGE port on the WJ-HD500B and the EXT IN port on the 1st DVD Extension Unit with the supplied (WJ-HDE510B) SCSI cable.

Plug the cable end with magnetic core into the EXT STORAGE port, and the other ends into the EXT IN port.

Repeat the connection steps for any subsequent extension units.

The system can be expanded by up to 6 Extension Units. To connect the other Extension Units, refer to the operating instructions of each unit for further information.

Digital Disk Recorder
WJ-HD500B	COPY port
SCSI ID=6 and 7

EXT
STORAGE		EXT STORAGE					COPY				GEN-LOCK OUT		SIGNAL GND
IN
SPOT										DATA	REMOTE(WV-CU50)				10/100BASE-T	AC
												SERIAL
OUT																IN
OUT			CONTROL			ALARM		MODE
MULTI SCREEN OUT AUDIO		14			11		9			6	5	4	3	2	1
16	15		13	12		10		8	7
IN
																ON
																OFF
OUT
16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	POWER
							VIDEO
				CONTROL port
SCSI cable
(supplied)									SCSI cable (supplied)

			DVD Extension Unit #1
	COPY		WJ-HDE510B
EXT IN	IN		SCSI ID=0 to 5
	EXT IN	COPY IN
	EXT OUT		AC IN
		G		POWER
	SCSI ID	THERMAL ERROROUT
		NC		ON
HDD	-	TERMINATOR		OFF
INSTALLED	+	ON
NOT INSTALLED		OFF
				SIGNAL GND
EXT OUT	SCSI cable
	(supplied with
EXT IN	Extension Unit)
			Terminal board
	EXT IN
		OUT
	EXT OUT	ERROR
			AC IN	POWER
	SCSI ID	GND THERMAL NC		ON
	–	TERMINATOR		OFF
	+	ON
		OFF

SIGNAL GND

Extension Unit #2

WJ-HDE500B/HDE505B

SCSI ID=0 to 5

●Switch Settings

1.Set MODE switch #2 on the rear of the WJ-HD500B to ON when connecting a DVD Extension Unit with an optional HDD.

2.Set the SCSI ID for the DVD Extension Unit and each subsequent Extension Unit with the – or + selector on the rear of each Unit.

0 to 5: IDs for Extension Units.

Note: SCSI ID 6 and 7 are reserved for the WJ-HD500B Digital Disk Recorder.

3.Set the termination switches on the rear of the Extension Units to ON or OFF.

ON: Is applied to the extension unit located at the end of the SCSI chain.

OFF: Is used for units other than the end unit.

1 2 3 4

ON

MODE

SCSI ID

–

1

+

ON

OFF

23