Panasonic WJ-HD500B Communication Setup, PS Data Setup, Unit Address Setting, Baud Rate, Data Bit

COMMUNICATION SETUP

The procedures described below let you set the parame- ters for the Disk Recorder to communicate with external devices.

1.Move the cursor to COMMUNICATION SETUP in the WJ-HD500 SETUP menu by pressing the C or D but- ton, then press the SET button.

The COMMUNICATION SETUP menu shown below appears on the monitor screen.

8 COMMUNICATION SETUP

PS•Data SETUP

RS232C SETUP

NETWORK SETUP
DHCP	OFF
IP ADDRESS	192.168.000.010
NETMASK	255.255.255.000
GATEWAY	192.168.000.001

2.Select an item or item parameter in the menu by press- ing the D or C button.

3.To return to the previous setup menu, press the SETUP/ESC button.

●Unit Address Setting

This item lets you set the unit address of the Disk Recorder in the system for RS-485 communication.

1.Move the cursor to the UNIT ADDRESS parameter by pressing the D or C button.

2.Select the unit address number to be used for RS-485 communication by pressing the + or - button.

Select a parameter value between 001 and 099.

The factory default setting is 001.

2.Select an item or item parameter in the menu by press- ing the D or C button.

3.To return to the previous WJ-HD500 SETUP menu, press the SETUP/ESC button.

■PS • Data Setup

These items let you set the parameters for communication between the System Controllers and the Disk Recorders when the system is controlled with the PS • Data mode (Panasonic Security Data).

1.Move the cursor to PS • Data SETUP in the COMMUNI- CATION SETUP menu by pressing the C or D button, then press the SET button.

The PS • Data SETUP menu shown below appears on the monitor screen.

8-1 PS•Data SETUP

UNIT ADDRESS	001
BAUD RATE	9600
DATA BIT	8
PARITY CHECK	NONE
STOP BIT	1
WAIT TIME	OFF
ALARM DATA	1S

CAMERA NUMBER SETUP

●Baud Rate

This item lets you set the transmission speed for RS-485 communication.

1.Move the cursor to the BAUD RATE parameter by pressing the D or C button.

2.Select the desired transmission speed shown below by pressing the + or - button.

↔2 400 ↔ 4 800 ↔ 9 600 ↔19 200 ↔ 38 400 ↔

The factory default setting is 9 600 bps.

●Data Bit

This item lets you set the number of data bits for RS-485 communication.

The factory default setting is 8 bits and fixed.

68