●Stop Bit
This item lets you set the number of stop bits for
1.Move the cursor to the STOP BIT parameter by press- ing the D or C button.
2.Select either 1 or 2 for the number of stop bits by press- ing the + or - button.
The factory default setting is 1 bit.
●Wait Time
This item lets you set the waiting time in
1.Move the cursor to the WAIT TIME parameter by press- ing the D or C button.
2.Select OFF, 100, 200, or 1 000 ms for the wait time by pressing the + or - button.
When no transmission is needed, select OFF.
The factory default setting is OFF (no retry).
■Network Setup
When the optional Network Board is installed in the Disk Recorder, the Disk Recorder can be controlled from a Client PC via the Ethernet Hub.
These items let you set the parameters for communication between the
1.Set DHCP (Dynamic Host Configuration Protocol) to ON or OFF.
The default setting is OFF.
ON: Uses DHCP. The DHCP server will assign the net- work parameters.
OFF: Does not use DHCP. You need to enter the follow- ing parameters if you wish to change them from the default settings.
2.Move the cursor to IP ADDRESS in the COMMUNICA- TION SETUP menu by pressing the C or D button, then press the SET button.
The cursor moves to the right editing area.
3.Select the value for the IP Address by pressing the + or - button.
4.Move the cursor to the right by pressing the B button, then select the value for the IP Address by pressing the + or - button.
5.Repeat the above steps 2 and 3 until the IP Address is completed.
6.When the IP Address is completed, press the SETUP/ESC button to return the cursor to IP ADDRESS in the menu.
7.Similarly repeat the above steps 1 to 5 to set the Netmask and Gateway.
8.To return to the previous setup menu, press the SETUP/ESC button.
71