Quick guide
Initial auto installation
When the TV is powered on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.
Confirm the following before turning on the power
EIs the antenna cable connected? E Is the AC cord plugged in?
E Is the MAIN POWER switch turned on (;)?
1 Press <aon the TV.
• The initial auto installation wizard appears.
2Setting the OSD language.
Press a/b/c/dto select the desired language, and then press ;.
3Selecting the location of the TV.
|
|
|
|
|
| HOME |
| STORE |
|
|
|
|
|
|
Press c/dto select where you will use this TV, and then press ;.
•The confirmation screen pops up only when selecting “STORE”. Press c/dto select “Yes” or “No”.
•HOME: “STANDARD” will be the default value for the “AV mode” setting.
•STORE: “DYNAMIC (Fixed)” will be the default value for the “AV mode” setting. If the “AV mode” is changed, the TV will automatically switch back to “DYNAMIC (Fixed)” when there is no signal input from the TV or remote control unit for 30 minutes.
•STORE: A demonstration image will be displayed after initial auto installation is completed. If you have chosen “STORE” by mistake, go to “Setup” > “View setting” > “Reset” > select “HOME” again.
4Starting channel search.
|
|
|
|
|
| Digital search |
| Analogue search |
|
|
|
|
|
|
Press c/dto select “Digital search” or “Analogue search”, and then press ;.
•To watch both analogue broadcasts and digital broadcasts, you should perform the auto installation setting for each format (Page 30).
•If you want to search for more broadcasts, execute “Additional search” from the “Programme setup” menu (Pages 30_32).
NOTE
•If you turn off the power on the TV while performing a channel search, the initial auto installation wizard will not appear. The auto installation function allows you to execute the installation again from “Setup” > “View setting” (Page 30).
•The initial auto installation wizard will abort if you leave the TV unattended for 30 minutes before searching for channels.
•After initial auto installation is completed, the default PIN is automatically set to “1234”. To change the PIN setting, refer to Password/Lock settings (Page 33). To clear the PIN setting (PIN input will no longer be needed), refer to CLEARING THE PIN (Page 50).
Digital broadcast setting
Press c/dto select “Terrestrial” or “Cable”, and then press ;.
|
|
|
|
|
| Terrestrial |
| Cable |
|
|
|
|
|
|
ESearching for terrestrial broadcasts
The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.
• To abort the initial auto installation in progress, press 6.
NOTE
•When regional services overlapps causing conflicts where the services compete for the same number, the receiver displays a menu to allow the viewer selecting a target region for the conflict resolution.
11