Sylvania A01PDUH Preparation, Connection to Cable Receiver or, Satellite Box, Antenna Connection

PREPARATION

No supplied cables are used with these connections:

Please purchase the necessary cables at your local store. High Speed HDMI Cable (also known as HDMI category 2 cable) is recommended for the better compatibility.

Before you connect:

Be sure your antenna or other device is connected properly before plugging in the AC power cord.

English
Connection to Cable Receiver or	INTRODUCTION
Satellite Box
Use an HDMI or component video cables to connect the
HDMI or the Component Video Input jacks of the unit to
the HDMI or the component video output jacks of the cable
receiver / satellite box.
If you connect to the unit’s Component Video Input jacks,	PREPARATION
satellite dish
connect audio cables to the Audio L/R Input jacks right beside
the Component Video connector.
e.g.)

Antenna Connection

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF analog

or DTV antenna

RF coaxial cable

or

cable TV signal

rear of this unit

Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. [Initial Setup] ➠ p.15

Note

•If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.

•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

•For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than a set top or inside antenna.

•To switch your reception source easily between antenna and cable, install an antenna selector.

•If you are not receiving a signal from your cable service, contact the Cable provider.

or	RF coaxial cable	WATCHINGTV
		ANT IN

cable TV signal	cable receiver /
including PPV					STEREO
	satellite box				PCM		OPTIONAL
HDMI OUT	or	AUDIO OUT		COMPONENT VIDEO OUT
		L	R	Y	Pb/Cb	Pr/Cr
							SETTING
				(green)	(blue)	(red)
	HDMI cable						TROUBLESHOOTING
	or	component video cables
		(red / blue / green) and audio
					cables
						or	INFORMATION
side or rear of
this unit

You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jacks because they might have different output jacks.

Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable / satellite provider.

9

EN