Supplied Accessories, Attaching the Base

Supplied Accessories

Owner’s manual										Quick Start
(1EMN26439)										(1EMN26440)

Remote control

(NH200UD)(1EMN24700)

AC power cord (WAV0162LW001) or (WAV0162LTE03) or (WAV152ZHN001)

Batteries	Screw kit
(AAA, 1.5V x 2)	for attaching the base
	(1ESA23096)
AAA
AAA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Note

If you lose the screws, please purchase M5× 12 Phillips head screws at your local store.

English

		INTRODUCTION
Attaching the Base
You must attach the base to the unit to have it as a table top

unit. Be sure the front and rear of the base match the proper
direction.
1 Spread a thick and soft
1 Spread a thick and soft
	cloth over a table as
	cloth over a table as	PREPARATION
	shown.
	shown.
	Place the main unit face
	Place the main unit face
	up onto it. Make sure not
	to damage the screen. At
	least 2 people are required
	for this step.
	for this step.
2 Insert 2 hooks under the
2 Insert 2 hooks under the		WATCHING
	bottom of the main unit	WATCHING
	bottom of the main unit
	into base holes. (shown by
	arrow ➀), then move the
	base in the direction as	TV
	shown by arrow ➁ until it	TV
	shown by arrow ➁ until it
	stops and the 6 mounting
	stops and the 6 mounting
3	holes are aligned.	OPTIONAL
	Drive Phillips pan screws	OPTIONAL
	Drive Phillips pan screws
	into the 6 threaded holes
	at the bottom of the base	SETTING
	until they are tight.	SETTING
	until they are tight.


To remove the base from this unit		TROUBLESHOOTING
To remove the base from this unit
• Unscrew the Phillips pan screws on step 3
	After the screws are removed, move the base in the opposite direction as
	shown by arrow ➁ on step 2, then pull the base up toward the front of the
	unit. Be careful not to drop the base when you remove it.
Note
• When attaching the base, ensure that all screws are tightly fastened. If the

	base is not properly attached, it could cause the unit to fall, resulting in	INFORMATION
	upward. If it's not upward, the 2 hooks don't ﬁt in the base.	INFORMATION
	injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is
	larger than this unit.
• Make sure the table is in a stable location.
•	When attaching the base, ensure that FRONT ↑ written on the base is

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

ATSC : Digital TV operation

NTSC : Analog / Cable TV operation

•If neither symbol appears, the operation is applicable to both.

Fixing the Unit on Your Furniture

Screw this unit on your furniture tightly using wood screws (not supplied) in the 2 holes at the back of the base as shown.

•Recommended screw dimension : 5.1 x 20 mm rear of this unit

Note

•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.