ILO DTV2784 Connections to other equipment, Selecting the video input source, Rear of the TV

Connections to other equipment

The exact arrangement you use to interconnect various video and audio components to the TV is dependent on the model and features of each component. Check the Owner's Manual provided with each component for the location of video and audio inputs and outputs.

The connection diagrams below are offered as suggestions. You may need to modify them to accommodate your particular assortment of components. The diagrams are intended to show component video and audio interconnections only.

Selecting the video input source

Press TV/AV to view a signal from another device connected to your TV, such as a VCR or DVD player. You can select ANT, VIDEO1, VIDEO2 (on the front panel), or COMPONENT depending on which input jacks you used to connect your devices.

Pressing TV/AV on the remote control displays the current signal source (press TV/AV again or 0-3to change).

SOURCE SELECTION

0.ANT

1.VIDEO1

2.VIDEO2

3.COMPONENT

/0-3 : SELECT

To connect the TV to a VCR

To Audio/Video OUT

Audio/Video cord (not supplied)

To AUDIO/VIDEO IN

Rear of the TV

To connect the TV to a VCR with an S-Video cord

If you connect a VCR with a S-VIDEO cord to the S-VIDEO IN jack on the rear of the TV, you must also connect the audio cords to the AUDIO IN jacks on the rear of the TV. The S-VIDEO cord only carries the video signal. The audio signal is separate.

To S-Video OUT

To Audio OUT

To AUDIO IN

Audio cord (not supplied)

S-Video cord (not supplied)

To S-VIDEO IN Rear of the TV

NOTE:

When the S-video cord and the video cord are connected to each jack at the same time, the S-video cord takes precedence over the video cord.

10