Panasonic AJ-D850P manual Audio Setting Description

Setup menus

USER menu

<AUDIO> (continued)

	Item		Setting
						Description
No.	Superimposed	No.		Superimposed
	display			display
713	MONI CH	0000			MANU	This selects the monitor output.
	SEL	0001			AUTO1	0: The output is as selected in MONITOR SELECT.
		0002			AUTO2	1: The output defaults to CUE except when speed factor is
						between –0.43⋅and 1⋅, inclusive, in which case output is
						PCM AUDIO.
						2: The output defaults to CUE except in PLAY mode, in which
						case output is PCM AUDIO.
						<Note>
						These menu settings are valid when CH1 or CH2 has been
						selected by the MONITOR SELECT L/R switches on the front
						panel. (When CUE has been selected, the CUE signal will be
						output at all speeds regardless of the above menu setting.)
714	REC CH1	0000			CH1	This selects the input signal to be recorded on the audio CH1
		0001			CH2	track.
		0002			CH1+2	0: Audio input CH1 signal.
						1: Audio input CH2 signal.
						2: Mixed audio input CH1 and CH2 signal.
715	REC CH2	0000			CH1	This selects the input signal to be recorded on the audio CH2
		0001			CH2	track.
		0002			CH1+2	0: Audio input CH1 signal.
						1: Audio input CH2 signal.
						2: Mixed audio input CH1 and CH2 signal.
716	REC CUE	0000			CUE	This selects the input signal recorded in CUE.
		0001			CH1	0: CUE input
		0002			CH2	1: The signal selected in Setup Menu No. 714 is recorded.
		0003			CH1+2	2: The signal selected in Setup Menu No. 715 is recorded.
						3: A mixed signal of the signals selected in Setup Menu No.
						714 and Setup Menu No. 715 is recorded.
718	DV	0000			ST1	This selects the AUDIO CH1 and CH2 output signals during
	OUTPUT	0001			ST2	DV or DVCAM format playback.
		0002			ST1+2	0: The CH1 track signals are output to CH1 and the CH2 track
						signals to CH2.
						1: The CH3 track signals are output to CH1 and the CH4 track
						signals to CH2.
						2: The mixed CH1 and CH3 track signals are output to CH1
						and the mixed CH2 and CH4 track signals to CH2.
						<Note>
						This item setting is valid only when the tape recorded on the
						four channels of the DV or DVCAM format is played back.
719	PB FADE	0000			AUTO	This selects the processing method for the audio edit points
		0001			CUT	(IN point, OUT point) during playback.
		0002			FADE	0: According to the status during recording.
						1: Forced CUT
						2: Forced FADE
720	EMBEDDED	0000			OFF	This selects whether to superimpose the audio data onto the
	AUD	0001			ON	serial output.
						0: Data is not superimposed.
						1: Data is superimposed.
						<Note>
						This item is valid when the optional serial interface board has
						been installed.
722	INT SG	0000			OFF	This selects whether to use the internal signals as the audio
		0001			ON	input signals.
						0: The internal signals are not selected.
						1: The internal signals are selected.
						<Note>
						The internal signals have a frequency of 1 kHz.

The underline on the setting item denotes the initial setting.

– 72 –