Panasonic AJ-YA120AG SYS Format, PB Format, Manual, Auto, Format SEL, Hd-Lp, Hd-Sp, HD Frequency

Setup menus

BASIC

	Item		Setting
					Description of settings
No.	Superimposed	No.	Superimposed
	display		display
020	SYS FORMAT			For setting the format in which to record or play back the signals including the HD
				REF signals.
		0000	1080i	0:	1080i mode
		0001	720p	1:	720p mode
022	PB FORMAT			For setting the format in which to play back the tape.
		0000	MANUAL	0: The tape is played back in the format selected by the menu item No.020 [SYS
					FORMAT] setting.
		0001	AUTO	1: The tape is played back in the format selected by the format in which the tape
					was recorded.
023	FORMAT SEL			For selecting the format when MANUAL is selected as the menu item No.022 [PB
				FORMAT] setting.
		0000	HD-LP	0: The DVCPRO HD-LP format is selected, and the format follows the menu item
					No.020 [SYS FORMAT] setting.
		0001	HD-SP	1: The DVCPRO HD format is selected, and the format follows the menu item
					No.020 [SYS FORMAT] setting.
		0002	422	2: The DVCPRO50 (422) format is selected.
		0003	411	3: The DVCPRO (411) format is selected.
		0004	420p	4: The DVCPROP (420p) format is selected.
		0005	DV	5: The DV format is selected.
		0006	DVCAM	6: The DVCAM format is selected.
030	HD FREQUENCY			For setting the field frequency.
		0000	59/23	0: The field frequency is set to 59.94/23.98 Hz.
		0001	60/24	1: The field frequency is set to 60/24 Hz.
				<Note>
				The field frequency which is set here takes effect only when there is no input which
				supports the OUT REF setting.
				If there is an input which supports the setting, the field frequency is consistent with
				the field frequency of input.
031	OUT REF			For selecting the video output reference.
		0000	AUTO	0: The REF signal (HD/SD) which is input to the REF connector is automatically
					identified and serves as the reference.
					If no signal is supplied to the REF connector, the HD serial input signal serves
					as the reference.
					If neither the REF input signal nor HD serial input signal is supplied, the internal
					sync signal serves as the reference.
		0001	INPUT	1: The HD serial input signal serves as the reference.
					If this signal is not available, the unit’s internal reference is used.
		0002	HD REF	2: The HD REF input signal serves as the reference.
					If this signal is not available, the unit’s internal reference is used.
		0003	SD REF	3: The SD REF input signal serves as the reference.
					If this signal is not available, the unit’s internal reference is used.
				<Note>
				When “1394” is selected as the menu item No.600 [VIDEO IN SEL] setting, the
				output picture in the E-E mode or output picture during recording may be disturbed
				in the vertical direction even when this item is set. However, there will be no
				problem with the pictures which are recorded on the tape.

“” indicates the factory setting.

35