JVC SR-VS30U manual If your DBS receiver has audio/video output connectors

Filename [VS30U_1a-EN.fm]
VS30U_1a-EN.fm Page 23 Thursday, January 31, 2002 3:35 PM	Masterpage:Right-NoTitle0

EN 23

DBS Receiver Control Setting

Place the DBS (Direct Broadcast Satellite) receiver on top of the VCR. Attach the VCR’s Controller to the top of the VCR with the Controller’s transmitter pointed towards the DBS receiver’s remote sensor.

ATTENTION:

The Controller can also control a cable box. If both a DBS receiver and a cable box are used, position the Controller so its signal reaches the remote sensors of both the DBS receiver and cable box.

The following procedure is required if you receive satellite channels through a DBS (Direct Broadcast Satellite) receiver. The Controller allows the VCR to automatically switch the DBS receiver’s channel during timer recording.

NOTES:

●The VCR can automatically change the DBS receiver channels

using the Controller when the VCR has been programed using “Express Timer Programing” (
pg. 46).

Because satellite programing does not use PlusCode, the

Controller cannot change the DBS receiver channels during “VCR Plus+® Timer Programing” (
pg. 42).

●If a cable box is also used, it is recommended that you connect the DBS receiver to your VCR’s audio/video input connectors and the cable box to your VCR’s antenna input terminal.

DBS receiver

Your VCR

Controller (suggested locations)

DBS receiver

Installing Controller

A Situate the Controller.

Place the Controller so that the path between its transmitter and the DBS receiver’s remote sensor is unobstructed.

B Attach the Controller.

Fix securely using the adhesive strip attached on the back of the Controller.

C Make connections.

	To RF	To Audio/
	output	video
Controller	Transmitter	output
		or
	To	To
	ANTENNA	AUDIO/
	IN	VIDEO IN

Your VCR

CABLE

BOX

If your DBS receiver does not have audio/video output connectors

Connect the RF output terminal on the DBS receiver to the ANTENNA IN connector on the rear of your VCR.

If your DBS receiver has audio/video output connectors

Connect an audio/video cable between the AUDIO/ VIDEO IN connectors on the rear of the VCR and the audio/video output connectors on the DBS receiver.

NOTE:

When connecting your DBS receiver, refer to its instruction manual.

D Connect the Controller to VCR.

Connect the Controller to the CABLE BOX connector on the rear panel.

How to control the DBS receiver

This VCR has two separate methods to control your DBS receiver.

●The VCR’s wireless Remote can control your DBS receiver. This eliminates the need for a separate DBS receiver’s Remote.

●The VCR’s Controller can also control your DBS receiver. This allows the VCR to change your DBS receiver’s channel

number during timer recording.

Each method must be set up separately. To set up the VCR’s Remote, refer to page 69. To set up the Controller, go to page 24.

Page 23

January 31, 2002 3:35 pm