JVC SR-VS30U manual Select the program to modify, Overlap each other on the VHS deck

Filename [VS30U_2-EN.fm]
VS30U_2-EN.fm Page 51 Thursday, January 31, 2002 3:38 PM	Masterpage:Right-NoTitle0

					EN 51
				When programs overlap each other
ATTENTION
If there is a conflict in the timer schedule and one				If “PROGRAM NOT COMPLETED PROGRAM OVERLAP”
program overlaps with another, only the parts shown				appears, you have another program overlapping the program
below in gray will be recorded.				you have just made.
Pattern 1:	The program with the lower program number			The Program Check screen appears and conflicting programs
				will start blinking.
	will be recorded.
Program 1
		CH10
Program 2
		CH40	Not recorded

Pattern 2: The program starting earlier will be recorded.

Program 1

CH10

Example: Program 1 (you have just made) and Program 4

overlap each other on the VHS deck.

Program 2

CH40

Not recorded

Pattern 3: The program starting earlier will be recorded,

A Confirm the overlapping programs.

followed by the remaining portion of the other

program.

Overlapping programs blink on the TV screen.

10:00

11:00

12:00

Program 1

B Select the program to modify.

CH10

Program 2

CH40

Press rt, then press OK or e.

Not

recorded

● You can only select one of the overlapping programs.

NOTE:

ATTENTION

If you do not mind this overlap, press PROG to finish the timer

If the program you have

program setting. See “ATTENTION” in the left column. The

just made and “DV” are

program with the lower program number will be recorded and

the other one will not be recorded correctly. If no changes are

blinking, there is a

made for approximately 3 minute, the VCR will return to the

conflicting program on the

normal screen.

DV deck.

A Press rt to move the

C

Cancel or change program setting.

highlight bar to “DV”,

then press OK or e.

To cancel a program, press CANCEL when the Program

DV Program Check

screen you do not want is shown. “PROGRAM

screen appears.

COMPLETED” appears on the TV screen for about 5

B Cancel or change

seconds, then the normal screen appears.

program setting as

To change a program, press the appropriate button:

described in step 2 and

START+/–,STOP+/–,DATE+/–,CH+/–, and/or SP/EP

3 in the right column.

(

p

) when the Program screen on which you want to

make changes is shown, then press OK. “PROGRAM

COMPLETED” appears on the TV screen for about 5

seconds, then the normal screen appears.

NOTE:

If the overlap is not yet solved, or another overlap occurs with

the timer program setting after making the last correction on a

program, the conflicting programs will be shown on the Program

Check screen again. Repeat the above steps again until the

overlap is solved.

Page 51

January 31, 2002 3:37 pm