JVC SR-VS30U manual Cable Box or DBS Receiver Users, Guide Channel Number Set

Filename [VS30U_2-EN.fm]
VS30U_2-EN.fm Page 43 Thursday, January 31, 2002 3:38 PM	Masterpage:Right-NoTitle0

EN 43

	NOTES:
G Set the tape speed.
	● To Change The Stop Time . . .
For the VHS deck	. . . press STOP +/– in step 6. You can compensate for
	anticipated program schedule delays.
Press SP/EP (p).	● To Timer-Record Weekly Or Daily Serials . . .
For the DV deck	. . . in step 6, press WEEKLY (number key “9”) for weekly
	serials or DAILY (M–F) (number key “8”) for daily serials
Press SP/LP (p).	(Monday — Friday). Either “WEEKLY” or “DAILY” appears on
	the TV screen. Pressing the button again makes the
H Return to the normal screen.	corresponding indication disappear.
	● In case of a power failure after programing, the VCR’s memory
Press PROG or OK. “PROGRAM COMPLETED” appears	backup keeps your selections for approximately 10 minutes.
	● You can program each deck to timer-record as many as 6
on the TV screen for about 5 seconds, then the normal	programs. If you try to program the VCR to record a seventh,
screen appears. If “PROGRAM NOT COMPLETED	“PROGRAM FULL” appears on the TV screen. To record the
PROGRAM OVERLAP” appears on the TV screen, see	extra program, you must first cancel any unnecessary
page 51.	programs ( pg. 50).
● Repeat steps 3 – 8 for each additional program.	● It is not possible to timer-record the same program on both the
	VHS deck and the DV deck simultaneously.
I Engage the VCR’s timer mode.	● During timer recording, it is not possible to change the
	recording deck (VHS or DV).
Press TIMER. The VCR turns off automatically and “#”	● If the times that are programed for recording on the DV deck
	and on the VHS deck overlap, the earlier start time takes
appears on the front display panel.	precedence. If the start times are the same, the VHS deck takes
● To disengage the timer mode, press TIMER again.	precedence.

		ATTENTION
Cable Box or DBS Receiver Users
		Guide Channel Number Set
To timer-record a cable or satellite broadcast using the VCR
		“GUIDE CHANNEL SET” appears after performing step 6 if
plus+ system:
		the Guide Channel number for the PlusCode number you
A	Perform “Cable Box Control Setting” ( pg. 20) or “DBS
		entered has not been set.
	Receiver Control Setting” ( pg. 23).
		If you want to set the Guide Channel number for the TV or
B	Perform steps 1 – 9.
		cable station, press number keys or rt to input the channel
C	Leave the power of cable box or DBS receiver on.
		position number on which your VCR or cable box receives
		that station, then press OK or e to set the Guide Channel
IMPORTANT		number. VCR Plus+ Program screen appears.
If you have moved to a different area or if a broadcasting			If you receive your channels
			with a cable box and if you
station's channel number has been changed, the wrong VCR
			have properly set your
CH or CABLE CH number will be displayed on the VCR
			Controller, “CABLE CH”
Plus+ program screen in step 6. When this happens, set the
			appears in place of “VCR
correct Guide Channel number for that station. ( pg. 44,
			CH”. If not, refer to pages 20.
“Changing VCR Plus+® Setting”)

Page 43

January 31, 2002 3:37 pm