JVC SR-VS30U manual Setting DBS receivers brand and channel, Turn on the DBS receiver

Filename [VS30U_1a-EN.fm]

VS30U_1a-EN.fm Page 24 Thursday, January 31, 2002 3:35 PMMasterpage:Left

24 EN			INITIAL SETTINGS (cont.)
			D Access the Initial Set screen.
			Press rt to move the
			highlight bar (arrow) to
			“INITIAL SET”, then press OK
			or e.
T	W	3
1	2
			2
4	5	6	E Access the DBS Receiver Set screen.
7	8	9
	0		Press rt to move the
			4
			highlight bar (arrow) to “DBS
			RECEIVER SET”, then press
			OK or e.
1	DV	S-VHS

Setting DBS receiver's brand and channel

After installation, set the DBS receiver’s brand and channel correctly; otherwise, the Controller cannot work correctly.

Turn on the TV and select the AV mode.

A Turn on the VCR.

Press POWER.

B Turn on the DBS receiver.

Turn on the DBS receiver’s power.

C Access the Main Menu screen on the VCR.

Press MENU.

F Select the DBS receiver’s channel.

Your selection depends on how the DBS receiver is connected to your VCR.

If the DBS receiver is connected to your VCR’s ANTENNA IN connector on the rear panel, press rt until

the channel number

representing the DBS receiver’s output (CH3 or CH4) appears on the screen.

If the DBS receiver is connected to your VCR’s AUDIO/ VIDEO IN connectors on the rear panel, press rt until

“ON L-1 (REAR)” appears on the screen.

If you do not use a DBS receiver, press rt until “OFF”

appears on the screen.

Page 24

January 31, 2002 3:35 pm