JVC SR-VS30U manual VHS deck, DV deck

Filename [VS30U_4-EN.fm]
VS30U_4-EN.fm Page 79 Thursday, January 31, 2002 3:45 PM	Masterpage:Right-NoTitle0

			EN 79
TIMER RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording won’t work.	● The clock and/or the timer have been set	Re-perform the clock and/or timer
		incorrectly.	settings.
		● The timer is not engaged.	Press TIMER and confirm that “#” is
			displayed on the front display panel.
		● Timer recording may not work when the	Set the channel position other than “F-1”
		VCR’s input mode is set to “F-1” for	before engaging to Timer-Standby mode.
		recording on the DV deck.
2.	Timer programing is not possible.	● Timer recording is in progress.	Timer programing can’t be performed
			while a timer recording is in progress.
			Wait until it finishes.
3.	“#” and “[” on the front display	● The timer is engaged but there’s no	For the VHS deck
	panel won’t stop blinking.	cassette loaded.	Insert a VHS (or S-VHS) cassette with the
			record safety tab intact, or cover the hole
			using adhesive tape.
			For the DV deck
			Insert a Mini DV cassette with the erase
			protection switch set to “REC”.
		● The end of the tape was reached during	The program may not have been recorded
		timer recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.
		● VHS deck
		The loaded cassette has had its record	Remove the cassette and cover the hole
		safety tab removed.	with adhesive tape, or insert a cassette
			with the record safety tab intact.
		● DV deck
		The loaded cassette has had its erase	Remove the cassette and set the erase
		protection switch set to “SAVE”.	protection switch to “REC”.
4.	“#” blinks for 10 seconds and the	● TIMER has been pressed when there are	Check the programed data and re-
	Timer mode is disengaged.	no programs in memory, or the timer	program as necessary, then press TIMER
		record information has been programed	again.
		incorrectly.
5.	The VCR Plus+ system does not timer-	● The VCR’s channel positions have been	Refer to “Guide Channel Number Set”
	record properly.	set incorrectly.	( pg. 44) and re-perform the procedure.
6.	The power shuts off and “[” won’t	● The end of the tape was reached during	The program may not have been recorded
	stop blinking.	Instant Timer Recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.

Page 79

January 31, 2002 3:45 pm