Marmitek Easycontrol 8 Troubleshooting, Remote control does not work or the codes are not stored

connected device is operated via your EasyControl 8 module (with RF signals). Use the Marmitek Home Control TM13 module (available separately) and connect your table lamp or other electrical appliance. Switch on/off: control everything with the EasyControl 8. The Home Control TM13 module converts the RF signals of the EasyControl 8 into an X- 10 signal that is then transferred via the mains. All the other X-10 modules that are con- nected to your mains, are also operated through the EasyControl 8 module. Read more about this subject on the Marmitek web site www.marmitek.com

5. Troubleshooting

The remote control does not work or the codes are not stored.

•Check whether you have pressed the right Mode button for the device you want to control.

•If the code does not work, you can try AutoSearch or enter the next code for your brand.

•Check whether the batteries have been placed correctly.

•To program the remote control you need two (new) AAA-alkaline batteries.

•If the remote control has lost the code, you may have to replace the batteries.

•If the LED stays lit, you need to replace the batteries.

•Restore the remote control to its factory settings.

•On www.marmitek.com you will find a list of FAQ’s.

Returning the Easycontrol 8 to the original factory settings

•Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit. Release SETUP.

•Press STOP (21) twice and release the button.

•Press Mute (5) and release the button.

•The LED will extinguish after a few seconds.

14 MARMITEK