Master TV Setup Procedure

Master TV Setup (Cont.)

1.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 15 to 22 for detailed information on all Installer Menu items.

a)Make sure the TV is ON. Then, use the Installer Remote to enter the PTC Installer Menu: Press MENU repeatedly until the on-screen display of the TV setup menus no longer toggles, and then press 9-8-7-6+ ENTER.

b)Set Installer Menu item 117 FACT DEFAULT to 001 and press ENTER on the Installer Remote.

This clears all Installer Menu custom settings, channel lineup, etc. and reloads the factory default settings. The value will change back to 0 after the PTC has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup.

c)Set Installer Menu item 003 BAND/AFC, as appropriate.

•	Broadcast: Set to	000.	•	HRC: Set to 002.
•	CATV: Set to 001	(default).	•	IRC: Set to 003.

d)Set any other Installer Menu items that affect your TV pro- gramming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc.

e)After you have adjusted all required Installer Menu item settings, press ENTER once on the Installer Remote to save your changes; then, press ENTER again to exit the menu.

2.Set up TV features.

On-screen setup menus control the features of the TV. Press MENU on the Installer Remote to access the TV setup menus, and then set Channel, Picture, Audio, Lock, Time, etc. options to the desired configurations. See also the Clonable TV Setup Menu Features list on page 11.

Note: If you intend to clone the PTC, remember that only one TV source’s clonable setup menu settings will be cloned. Thus, for a clone programmer, the TV setup menu settings should be applica- ble to either an analog channel or Aux input, while for a USB device / .tll file, the TV setup menu settings should be applicable to the analog or digital channel or Aux input to which the Target TV will be set during the Teaching process.

Note: If desired and if appropriate depending on the cloning method you intend to use (see “Cloning Methods” on previous page), you can run Auto Tuning (see step 3) prior to completing this step.

xxLD66xH PTC INSTALLER MENU

000	INSTALLER SEQ	000

UPN	000-000-000-000	ASIC D279
PTC	V1.00.016	CPU V1.21.00

Typical Installer Menu

Note: The Installer Menu header will vary depending on the TV you are setting up.

117	FACT DEFAULT	001
003	BAND/AFC	00X

Adjust the settings for these

Installer Menu items.

CHANNEL	PICTURE	AUDIO	TIME
OPTION	LOCK	INPUT	USB

Use the TV setup menus to set the TV features to the desired configuration for the end user.

(Continued on next page)

206-4200