LG Electronics 32LD555H, 47LD555H, 42LD665H, 37LD555H Verify the TV setup, Lock the channel lineup

Master TV Setup (Cont.)

(Continued from previous page)

5.Transfer the TV setup menu settings to the commercial controller (PTC):

2-5-5 + MENU Mode

Important: This step is essential for successful cloning using a USB memory device / .tll file or a clone programmer. Without this step, the PTC will not contain any of the TV setup menu settings.

a)After the TV channel lineup has been edited and channel label icons added, tune to the channel (source) for which you wish to transfer TV setup menu settings.

Note: If you intend to use a clone programmer for cloning purposes, this must be either an analog channel or Aux input.

b)Enter the Installer Menu, and press 2-5-5+ MENU on the Installer Remote to initiate the transfer of the Master TV Setup to the PTC. The TV exits the Installer Menu and then tunes through the channels in the channel lineup during the transfer. When the transfer is complete, the TV tunes back to the channel that was tuned before the transfer began.

Note: The maximum number of channels that can be transferred is 141. An attempt to transfer more than 141 channels will result in erratic TV tuning operation.

6. (Optional) Add Custom Channel and Aux Input Labels:

2-5-4 + MENU Mode
Note: This step is applicable only if you intend to clone the PTC. 2-5-4
			DIGITAL		19-3
+ MENU Mode enables you to add/edit channel icons and custom text
				MONO STEREO SAP
labels in the PTC once the Master TV Setup has been transferred as
described in the previous step.
Enter the Installer Menu, and press 2-5-4+ MENU on the Installer
				WXYZ
Remote. Add/edit custom text labels and/or change icons for the
Channel-Time on-screen displays (see 2-5-4 + MENU procedural		Custom text label “WXYZ” created
information on page 23). Note that broadcast digital channels often
				in 2-5-4 + MENU Mode.
already have a broadcaster generated label. When you are finished,
press MENU to exit 2-5-4 + MENU Mode.
7. Verify the TV setup.
As applicable, verify that the channel lineup, channel icons, and custom		028 CH. OVERIDE			000
text labels are correct. Also, make sure the TV features are set per your	After verifying the TV Setup, set Installer
requirements.		Menu item 028 CH. OVERIDE to 000.*
8. Lock the channel lineup.		* This step prevents end users from
Enter the Installer Menu. Set item 028 CH. OVERIDE to 000 and
		accessing channel settings (i.e., the
press ENTER to lock the channel lineup and restrict access to the TV		Channel Menu will be inaccessible/
setup menus. Press ENTER again to save your changes and exit the		grayed out).
Installer Menu.*

The Master TV Setup is now ready to be copied to the predetermined cloning tool—a USB memory device (.tlx or .tll file) or a clone programmer. See cloning procedures in this document.

14 206-4200