LG Electronics 32LD665H, 47LD555H FTG Mode via EBL Local Configuration, LD660H/LD665H Jack Panel

FTG Mode via EBL (Local Configuration)

The following steps outline local FTG configuration of individual TV EBLs using a direct PC-to-TV connection. Refer to the Free-To-Guest (FTG) Configuration Application manual for further information.

Notes: • FTG Device Configuration Application software is available online at: www.LGcommercial.com/ FTGsoftware.

•If the TV CPU is already in FTG Mode, you cannot use this procedure to make changes to the FTG Channel Map and FTG Installer Menu settings. Instead, refer to and use the processes described on pages 35 to 37 to reconfigure the TV CPU.

•If the preceding condition applies, but you wish to switch the TV to FTG Mode via EBL, refer to Reference section, “Resetting Factory Defaults on the TV(s),” for further information before proceeding.

1.	Install (if necessary) and launch the FTG Device
	Configuration Application (v5.0.0 or higher) on the
	PC that will be used to configure the EBL.
2.	Build an FTG Channel Map using the FTG Channel
	Map Editor in the FTG Channel Map Configuration
	Utility (or, if applicable, open an existing FTG
	Configuration [.rml] file).
	Note: Up to 141 logical channels can be defined in
	the FTG Channel Map.
3.	Connect the PC to the TV-LINK CFG jack on the
	TV’s rear connections panel using a USB-to-TTL

LD660H/LD665H Jack Panel

		LAN2	RESET
HDMI/DVI IN
2			TV-LINK CFG
1	..........

...............

RJP	RGB IN (PC)	AUDIO IN
INTERFACE		(RGB/DVI)

TV-LINK CFG

Use for direct PC-to- TV FTG configuration.

Laptop

PC

serial cable (TTL-232R-5V-AJ). If necessary, install

the device driver on the PC.

4. Turn ON the TV.

Note: If Installer Menu item 118 POWER SAVINGS

is set to 3 (default), the TV must be ON in order for

USB-to-TTL Serial Cable Required for direct PC-to-TV FTG configuration.

steps 5 and 6 below to be successful.

5. “Write” the FTG Channel Map to the EBL (switches

the EBL from Pass-through Mode to FTG Mode).

Note: After a “Write” of new data, the TV will briefly

display a green text banner that shows the EBL firm-

ware version and release date.

6. “Read” the current FTG Installer Menu settings from

the EBL using the FTG Installer Menu Configuration

Utility. If necessary to make changes to Installer

Menu items, “Write” them back to the EBL in FTG

Mode.

LV555H

Jack Panel

LAN1		RESET
	HDMI/DVI IN	UPDATE
	1	TV-LINK CFG
LAN2

RJP	..........
	. . . . .
INTERFACE	RGB IN (PC)	AUDIO IN
		(RGB/DVI)

TV-LINK CFG

Use for direct PC-to- TV FTG configuration.

Laptop

PC

7.	Save the FTG Channel Map and FTG Installer Menu
	settings to an FTG Configuration (.rml) file for future
	use.
8.	Tune the TV to a Logical Channel in the FTG
	Channel Map.

USB-to-TTL Serial Cable Required for direct PC-to-TV FTG configuration.

40 206-4200