Installation to Wood Stud Wall
WARNING
•Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
•Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
•Never tighten in excess of 80 in. • lb (9 N.M.).
•Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.
•Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install- ers are responsible to provide hardware for other types of mounting situations (not UL approved).
2 | Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to |
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall |
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Attach wall mount (A) to wall using two #14 x 2.5" flat head wood screws (H) as shown.
Skip to step 3 on page 7.
WOOD STUD WALL
WALL PLATE
H
A 
5 of 46 | ISSUED: |