For Flat Back Screen
Begin with the shortest length screw, hand thread through | |
| below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. |
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
fig. 2.1
SCREEN
SCREW
TILT BRACKET
(BB or CC)
For Bump-out or Recessed Back Screen
SCREEN | fig. 2.2 |
| |
SPACER | |
| SCREW |
TILT BRACKET
(BB or CC)
7 of 34 | ISSUED: |