Peerless Industries PT660, PWS421 instruction

Attaching Tilt Brackets to Screen using Bafﬂed Fastener Pack

WARNING

•Tighten screws so adapter brackets are ﬁrmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to screen or product may fail.

2	To prevent scratching the screen, set a cloth on a ﬂat, level surface that will support the weight of the screen. Place
	screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,

base, cover or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the tilt brackets to be attached. Select the small, medium, large or extra large screws from the bafﬂed fastener pack then attach tilt brackets to screen following ﬁgure 2.1 or 2.2.

NOTE: Top and bottom mounting holes on screen must be used for attaching brackets.

NOTE: Be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

HANDLES FACE OUT

CENTER BRACKETS VERTICALLY ON BACK

OF SCREEN

Note: "X" dimensions should be equal.

Notes:

•The number of fasteners used will vary, depending upon the type of screen.

•Multi-washers and spacers may not be used, depending upon the type of screen.

•Use the corresponding hole in the multi-washer that matches your screw size as shown.

MULTI-WASHER

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

NOTE: For ﬂat back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.

6 of 34

ISSUED: 02-05-09 SHEET #: 202-9272-4 04-12-10