Installing Adapter Brackets

WARNING

•Tighten screws so adapter brackets are ﬁrmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

•If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to screen or product may fail.

2	To prevent scratching the screen, set a cloth on a ﬂat, level surface that will support the weight of the screen.
	Place screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be

attached. Place adapter brackets (BB) on back of screen, align to holes, and center on back of screen as shown below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws, multi-washers, and spacers as shown in ﬁgure 2.1 or 2.2

NOTE: Top and bottom holes must always be used.

Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

CENTER BRACKETS VERTICALLY

ON BACK OF SCREEN

NOTE: "X" dimensions should be equal.

MULTI-WASHER

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

Notes:

•The number of fasteners used will vary, depending upon the type of screen.

•Multi-washers and spacers may not be used, depending upon the type of screen.

•Use the corresponding hole in the multi- washer that matches your screw size as shown.

•Slots in SF680 models are wider and require the use of the M8 washer.

NOTE: For ﬂat back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.

6 of 34

ISSUED: 11-09-07 SHEET #: 202-9253-4 08-31-10