Peerless Industries SF670-S, SWS510/SI, SWS510/BK, SF680-S, SF680P-S, SF670P For Flat Back Screen

For Flat Back Screen

2-1	Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (BB) into screen as
	shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over

tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

fig 2.1

SCREEN

MULTI-WASHER

SCREW

ADAPTER BRACKET (BB)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

For Bump-out or Recessed Back Screen

2-2	Begin with longer length screw, hand thread through multi-washer, adapter bracket (BB) and spacer in that order
	into screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into

place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

SCREEN

SPACER

fig 2.2

MULTI-WASHER

SCREW

ADAPTER BRACKET (BB)

If you have any questions, please call Peerless customer care at 1-800-865-2112.

7 of 34 ISSUED: 11-09-07 SHEET #: 202-9253-4 08-31-10