Icom HF/VHF/UHF ALL MODE TRANSCEIVER, iC-706MKTMG manual Installation, Single body mounting, Stand

■Installation

DSingle body mounting

MB-62 (optional)

Supplied with the MB-62*

*CAUTION: Non-supplied screws (longer than 8 mm) may damage the internal units.

INSTALLATION AND CONNECTIONS 2

DStand

To raise the stand:

With the transceiver upside down, pull the stand towards the rear panel and then upwards, as illus- trated below.

then up

Pull back

DFront panel separation

➀While pulling the panel release button towards you, slide the front panel to the right (fig. 1).

➁Attach the optional OPC-581 to the main body and tighten the supplied screw as in fig. 2.

➂Attach the other end of the OPC-581 to thefig. 1 detached front panel as in fig. 3.

fig. 3

fig. 2

DFront panel mounting

➀Attach the MB-63 to a flat surface using the two supplied screws (fig. 1).

➁Fix the detached front panel to the MB-63 as illus- trated in fig. 2.

Be careful of the orientation of the MB-63, other- wise, the front panel may become attached in the opposite direction.

fig. 1

fig. 2

10