Icom HF/VHF/UHF ALL MODE TRANSCEIVER manual One-touch repeater function, Auto repeater function

RECEIVE AND TRANSMIT 4

■One-touch repeater function

This function allows you to set repeater operation with the push of one switch.

➀Push [(Y)BAND]/[(Z)BAND] to select the 28 MHz band.

➁Rotate [DIAL] to select the operating frequency.

➂Push [MODE] one or more times to select FM.

➃Select M4 and turn the one-touch repeater function ON.

➥Push and hold [(F-2)DUP] to toggle the one- touch repeater function ON and OFF.

•When the one-touch repeater function is turned ON, “DUP” (duplex indicator) and “T” (tone frequency indicator) appear in the display.

•Be sure to set the duplex direction and offset in ini- tial set mode in advance (p. 52).

•Push [(F-2)DUP] to toggle the duplex direction.

							FM
								BLANK
S1	3	5 7	9	20	40	60dB	VFO A
PO				5		10		CH
M1 SPL						A/B A=B
							FM	T
							DUP	BLANK
S1	3	5 7	9	20	40	60dB	VFO A
PO				5		10		CH
M4 VOX						DUP TON

☞ NOTE: When you want to transmit a 1750 Hz tone, while pushing [PTT], push [(F-3)TON] in the M4 display during repeater operation.

■Auto repeater function

This function automatically activates the repeater set-
	FREQUENCY	DUPLEX DIRECTION
tings (DUP+ or DUP– and tone encoder ON/OFF)
when the operating frequency falls within the general	145.200–145.495 MHz	“DUP–” appears
output frequency range and deactivates them when	146.610–146.995 MHz
outside of the range.
	147.000–147.395 MHz	“DUP+” appears
Set the auto repeater function ON or OFF in initial set	442.000–444.995 MHz	“DUP+” appears
mode in advance (p. 53). When set ON, repeater set-	447.000–449.995 MHz	“DUP–” appears
tings are automatically activated according to the
table at right.
☞ NOTE: This function is available for the USA ver-
sion only.

32