Icom iC-706MKTMG, HF/VHF/UHF ALL MODE TRANSCEIVER manual Scan types, Preparation

5 MEMORY AND SCAN OPERATION

■Scan types

PROGRAMMED SCAN

Repeatedly scans between two scan edge frequencies (scan edge memory channels 1A and 1B).

	Scan
Scan edge 1A or 1B	Scan edge 1B or 1A
	Jump

This scan operates in VFO mode.

PRIORITY WATCH

Checks for signals on a memory or call channel while operating on a VFO frequency.

Memory channel watch		Call channel watch
VFO	Memory	VFO	Call
frequency	channel	frequency	channel

This scan operates in VFO mode.

MEMORY SCAN

Repeatedly scans all programmed memory channels.

BLANK

S(select)

Mch 2	Mch 3	Mch 4
Mch 1 S (select)		S (select) Mch 5
Mch 99	Mch 7	Mch 6
S (select)	S (select)

This scan operates in memory mode.

SELECTED MEMORY SCAN

Repeatedly scans all selected memory channels.

BLANK

S(select)

Mch 2	Mch 3	Mch 4
Mch 1 S (select)		S (select) Mch 5
Mch 99	Mch 7	Mch 6
S (select)	S (select)

This scan operates in memory mode.

■Preparation

• Channels

For programmed scan: Program scan edge frequen- cies into scan edge memory channels 1A and 1B (p. 34).

For memory scan: Program 2 or more memory chan- nels except scan edge memory channels.

For memory select scan: Designate 2 or more memo- ry channels as select memory channels—select a memory channel, then push [(F-2)SEL] in the S2 dis- play (memory mode) to designate the channel as a select memory channel.

For priority watch: Program 1 memory channel to be watched.

• Scan resume ON/OFF

You can select the scan to resume or cancel when detecting a signal, in initial set mode, item 21. Scan resume ON/OFF must be set before operating a scan. See p. 53 for ON/OFF setting and scan resume condi- tion details.

• Scan speed

Scan speed can be selected from 2 levels, high or low, in initial set mode. See p. 47 for details.

• Squelch condition

SCAN	PROGRAMMED	MEMORY SCANS
STARTS
	SCAN	PRIORITY WATCH
WITH
	The scan continues	Scan pauses on each
	until it is stopped	channel when the
	manually, and does	scan resume is ON;
	not pause even if it	not applicable when
SQUELCH	detects signals.	OFF.
	This is not applicable
OPEN	when the scan
	resume is OFF and a
	programmable step
	(more than 1 kHz) is
	selected.
	Scan stops when detecting a signal.
SQUELCH	If you set scan resume ON in initial set mode,
	the scan pauses for 10 sec. when detecting a
CLOSED	signal, then resumes. When a signal disap-
	pears while scan is paused, scan resumes 2
	sec. later.

43