Pelco c649m operation manual Timer Program Menu, Recording SET UP Menu, Start/End

6.6 TIMER PROGRAM MENU

			<TIMER PROGRAM>
		DW		START		END		HR
	1	- - -		- - : - -		- - : - -		- - -
	)2	DAY		08 : 40		17 : 25		L18EP
	3	MON		22 : 00		22 : 50		72EP
	4	WED		22 : 00		22 : 50		96EP
	5	SPL		20 : 30		23 : 30		2SP
Program	6	MON		10 : 10		11 : 15		SKIP
	7	SUN		23 : 30		00 : 15		6EP
number
	8	MON		21 : 00		21 : 54		2SP
			SPECIAL		DW MON-		FRI
Day of the
week
Recording start time						Recording end time
Next day indicator									Recording mode display
(program number) This number identifies the program. If						START/END			The VCR uses a 24-hour display. 00:00
the recording times of two programs									indicates midnight; 12:00, noon; and 15:00,
overlap, the higher program number has									3 p.m.
priority.

DW	Day of the week. DAY is used to record
	at the same time every day. SPL (spe-
	cial) uses the start/end days selected
	with SPECIAL DW at the bottom of the
	screen.

HR	This is the recording mode. SKIP indi-
	cates that timer recording is not performed
	during the set period. In 2H, 6H, L18H, and
	L24H mode, audio is also recorded.

Figure 11. Timer Program Illustration

6.7 RECORDING SET UP MENU

<RECORDING SET UP>		2H
ALARM REC MODE
ALARM REC DURATION		1M
EMERGENCY REC		OFF
REC MODE	NORMAL<SP>
ONESHOT•FIELD		1
ONESHOT•INTERVAL		SHOT

Figure 12. Recording Set Up

Menu

NOTE: Set the ALARM REC DU- RATION to MAN2 to use with the MX4000 Series Genex™ Multi- plexer.

NOTE: When using the MX4000 Series Genex™ Multiplexer, make sure the EMERGENCY REC set- ting is ON if the VCR is to record alarms only.

ALARM REC Sets the alarm recording time mode. When you turn the JOG

MODE dial, the display switches in the following order: 2H, 6H, L18H, L24H, 2H. (Refer to Section 8.3.3 for programming instruc- tions.) The default is 6H.

ALARM REC Sets the length of the alarm recording period. When you turn the

DURATION JOG dial, the display switches in the following order: 1M (minute), 2M, 5M, 10M, MAN1, MAN2, 15S (second), 30S, 45S, 1M. (Refer to Section 8.3.3 for programming instructions.) The default is 1M.

EMERGENCY Sets the emergency recording mode, as follows:

REC

•OFF – Starts alarm recording when the alarm signal is received during recording.

•ON – Starts alarm recording when the alarm signal is received, not only during recording but also when the power is OFF or when the tape is stopped.

The default is OFF. (Refer to Section 8.3.3 for programming instructions.)

Pelco Manual C649M (7/99) 23