1.1 SAFEGUARDS, WARNINGS, CAUTION, AND CARE
Observe the following WARNINGS before installing and using this product. Follow all warnings and instructions marked on the VCR.
Instructions
Read all the safety and operating instructions before operating the VCR. Keep the instructions for future reference. Follow all operating and use instructions. Heed all warnings on the equipment and in the operating instructions.
Installation/Servicing
Installation and servicing should be done by qualified service personnel only and conform to all local codes. Do not try to service this VCR yourself. Opening or removing covers may expose you to dangerous voltage or other hazards.
Damage Requiring Service
Unplug the VCR from the wall outlet and refer servicing to qualified service person- nel under the following conditions:
1.When the power cord or plug is damaged.
2.If liquid has been spilled, or objects have fallen into the VCR.
3.If the VCR does not operate normally when following the operating instruc- tions.
Adjust only those controls covered by the operating instructions. Improper adjustment of other controls may cause damage and will often require exten- sive work by a qualified technician to restore the VCR to normal operation.
4.If the VCR was dropped or the cabinet damaged.
5.When the VCR shows a distinct change in
Replacement Parts
Be sure the service technician uses only replacement parts Pelco recommends, or which have the same characteristics as the original part. Unauthorized substitu- tions may cause fire, electric shock, or other hazards.
Safety Check
Upon completion of any service or repair to the VCR, ask the service technician to perform safety checks to determine whether it is in safe operating condition.
Water/Moisture/Condensation
Do not use this VCR near water. It is designed for indoor use only and must not be installed where exposed to rain and moisture.
Do not place objects containing water, such as drinks, on top of the VCR.
If the VCR is exposed to a rapid increase in temperature (such as warming a cold room or after moving it from a cold location to a warm one), condensation may form on the tape transport mechanism inside the VCR. To prevent damage to the VCR or tapes, plug the VCR into the AC outlet and turn the power on for about two hours. Do not play back or record on the VCR during this time.
Condensation is likely to occur when:
1.The VCR is moved from a cold room to a warm room or from outdoors to indoors.
2.A cold room is heated quickly.
3.The humidity is very high.
Avoid using the VCR where cold air (such as from an air conditioner) will blow directly on it.
6 | Pelco Manual C649M (7/99) |