How to Set the Audio
Center and Surround Loudspeaker will automatically switch to small with the Large Menu Setting grayed out. The Subwoofer setting will switch On with the Off Menu Setting grayed out.
3. Use the Down directional Push-button to select FIL- TER followed by using the Down directional Push- button to select On or Off. When the Off position is selected the previously set Loudspeaker Size for the Front, Center and Surround will all change to the Large setting. The Subwoofer will switch to the On setting and all the Loudspeaker Menu Choices are grayed out. Refer to figure 27.
4.Press the RTRN (Return) Push-button to return to the SPEAKER CONFIGURATION Menu.
CHANNEL LEVEL ADJUSTMENTS:
A properly setup Home Theater Surround Sound System should have all Loudspeaker levels adjusted to the same starting reference volume level in the Listening/Viewing Area. The MVP861 includes a built-in test signal generator, which can have its output switched into each Loudspeaker manually or automatically. The desired test signal volume levels of each Loudspeaker can be determined, in the Lis- tening/Viewing Area, either by listening or with a sound pressure meter. Level adjustments are made in small steps (1dB) by using the MVP861 Remote Control Up or Down directional Push-buttons. The level can be ad- justed over a 10dB range.
Note: Before performing the Loudspeaker Level adjustments, you must first have completed the Loudspeaker Size adjustments.
1. Use the Down directional Push-button to select CHANNEL LEVEL followed by pressing the SELECT Push-button on the Remote Control. Refer to figures 28 and 29.
2. Use the Down directional Push-button to select TEST TONE then press the Right or Left direc- tional Push-buttons to select the MANUAL Selection Mode of operation. Refer to figures 30 and 31.
Note: The procedure used for making the Loudspeaker Level Adjustments is similar for both the Manual and Automatic Modes. The only difference is, in the Manual Mode the selection of the Loudspeaker is performed by using the Up or Down directional Push-buttons before adjustments are made. In the Automatic Mode, the MVP861 will switch to the next Loudspeaker three seconds after user adjustments have stopped. Refer to figures 32 and 33 if the Automatic Mode will be used.
3. Press the SELECT Push-button and then use the Right or Left directional Push-buttons to adjust the Loudspeaker Volume Level to match the volume level
Figure 26
Figure 27
of the other Loudspeakers. This may take several cycles through all the Loudspeakers to achive the de- sired results. If one of the Loudspeakers is quieter than the others, use it as a reference to match the other loud- speakers to.
4.When all the Loudspeakers are at the same volume level press the RTRN (Return) Push-button to stop the Channel Level Adjustments and return to the SPEAKER CONFIGURATION Menu.
DELAY TIME ADJUSTMENTS:
The following Delay Time Adjustments will electronically compensate for different Loudspeaker distances from the Listening/Viewing Area. Refer to figure 34 on page 30.