Sterling 882.00722.00 manual Typical Analog Options Analog options screen, Diagnostics Screen

Page 54

Figure 72: Typical Analog Options

Analog options screen

This screen is not used with the GH-M Rate Monitor. Adjust appropriately for GH Full Control units and GH-F units.

Figure 73: Typical Diagnostics Screen

Go back to

Engineering

Only Directory

Diagnostics Screen

Use this screen for trouble shooting and making tuning adjustments. Typically make an adjustment, reset high/lows, and then weight for some time to observe this page.

Chapter 7: Appendix

54 of 60

Image 54

Contents GH-M Rate Monitor Allen-Bradley Controller Write Down Your Serial Numbers Here For Future Reference Event of Shipping Damage Shipping InfoUnpacking and Inspection If the Shipment is Not CompleteWarranty Returns ReturnsCredit Returns Table of Contents Maintenance Safety How to Use This ManualSafety Symbols Used in this Manual Safety Tags and Warning Labels Description Follow all Safety Codes Wear Safety Glasses and Work GlovesResponsibility General ResponsibilityOperator Responsibility Remember Maintenance Responsibility Reporting a Safety DefectModels Covered in This Manual AccessoriesFunctional Description General DescriptionCustomer Service Typical Features and Components Mechanical FeaturesController Features Extruder Inductive Proximity Switch System Component DescriptionSurge Hopper Open Weigh HopperFunction Typical GH-M Operator Screen Operator Screens Common to all GH Systems Typical Setup Screens Optional Components Ethernet ModuleSafety Features Pneumatic Slide Gate below surge hopperLow Level Proximity Sensors Mounting Configurations InstallationMechanical Installation Uncrating the EquipmentElectrical Connections Machine MountPneumatic Connections Mechanical Set-up Weigh Hopper InstallationInitial Set-up Extruder RPM connectionFinal Connections Display Startup ScreenController Set-up GH Controller Menu Structure Recipe Page StartGH Calibration Weigh Hopper Load Cell CalibrationDisplay Calibration Menu Screen Hopper Size Setup WTP/RPM CalibrationExtruder Setup Hauloff Setup and Encoder CalibrationAlarm Setup Network SetupSetting Date and Time PanelView Configuration ScreenGH-M Operation Procedures OperationOperator Displays GH Full Control Operation Procedures Typical Operator Screen for GH Full Control systemGH-F Gravimetric Feeder Operation Procedures Common Screens Typical Manual Control Operator ScreenAlarm Flags Alarms with DescriptionsPrint Inventory Maintenance Preventative Maintenance ScheduleElectrical Preventative MaintenanceCorrective Maintenance Internal Components of the Control PanelInput Signals to Programmable Controller Output Signals from Programmable ControllerTroubleshooting IntroductionProblem Corrective action ProblemWarranty Restrictions Warranty and Spare PartsWarranty Specifications Warranty LiabilitiesCustomer Responsibilities Annex B InformationTypical Surge Hopper Assembly Parts List Addendum Service Supervisor Information PasswordsProgrammable Settings Typical Engineering Only Setup Screen Full Hopper Method Percent of hopper Method DefaultExtruder Pulse Count Method WTP/RPM FilterMax Allowed WTP/RPM Mechanical Options ScreenDiagnostics Screen Typical Analog Options Analog options screenAlarm Log Customer Setup MenuPassword Protection UnitsBelow are the items that can be accessed for the GH Hopper Allen-Bradley Communications ManualAppendix Reload TOO Long Fixed Decimal Explanation Service Department Sales Department Parts DepartmentContract Department