Customer Setup Menu
Password Protection
The Setup screen allows you to change the default User Password that the GH Hopper uses to lock out certain screens. The password by default is “5413”. To change the password, follow the steps listed below:
1.Set the Selected Operator to “USER” by touching the box located next to “Select Operator”.
2.Touch “New Password” and enter in a new password.
3.Touch “Verify Password” and enter in the same password.
4.A message telling you that the password has been changed will appear.
Figure 75: Typical User Password Setup Screen
2.Enter New Password Here
3.Verify New Password to
Finish
1.Select “USER”
4.Back to Setup Directory
If the Customer locks themselves out of a GH Hopper they can contact the manufacturer for a procedure that will let them back in. This password is used in several places throughout the GH Hopper, but can be bypassed by entering in the Manufacturer’s Service Password.
Units
This screen allows the user to change the GH Hopper’s unit of measurement. The entire GH Hopper can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be configured for either regardless of the GH Hopper’s units.
Alarm Log
This screen shows the last 100 stored alarms. The log can be viewed, printed and cleared.
Figure 79: Typical Alarm Log Screen
Clear Alarm
Log
Print Alarm
Log
Scroll Through
Alarm Log
Alarm Log
Go back to Setup Directory
Chapter 7: Appendix | 55 of 60 |