Toshiba RD-XS52SU, RD-XS52SC, RD-KX50SU owner manual Location of the required label

Page 3

Note to cable system installer:

This reminder is provided to call the cable system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

The instructions shall state that an ALL-POLE MAINS SWITCH with a contact separation of at least 3 mm in each pole shall be incorporated in the electrical installation of the building.

CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.

In the spaces provided below, record the Model and Serial No. located on the rear panel of your recorder.

Model No.

Serial No.

Retain this information for future reference.

Location of the required label

PRODUCT IS CERTIFIED BY THE MANUFACTURER TO

COMPLY WITH DHHS RULE 21 CFR SUBCHAPTER J

APPLICABLE AT THE DATE OF MANUFACTURE.

MANUFACTURED

1-1,SHIBAURA 1-CHOME,MINATO-KU,

TOKYO 105-8001,JAPAN

Introduction

Connections

Basic Setup

3

Image 3

Contents RD-XS52SU RD-XS52SC RD-KX50SU See service procedure This HDD/DVD video recorder employs a Laser SystemMay result in hazardous radiation exposure Location of the required label Important Safety Instructions Additional Safety Instructions Precautions When not in useIntroduction Exemptions Power OutageMoisture condensation occurs during the following cases Introduction PrecautionsDo not use the unit when moisture condensation may occur WaitConnections Registration card Installation procedureAccessories Remote control Batteries AAA x Video/Audio cable IR control cableAbout this product DVD-RAM discs for your personal library Using different disc types for different purposesFor recording / playback Disc Mark Specification Remarks Choosing a discDisc For playback only Disc Mark Specification RemarksDVD-RAM discs with cartridges are recommended for recording To protect recorded contentsOn DVD-RAM discs Introduction Choosing a discMarks on DVD video discs On DVD-R discsOn storing discs Structure of disc contentsOn cleaning discs On handling discsTable of Contents Close the cover Preparation of the remote controlOperating with the remote control Open the cover Insert batteries AAA sizeConnection procedure When you connect a TV equipped with audio/ video inputsWhen you connect an audio system Connections Connecting an antenna and TVConnect to a TV equiped with audio/video inputs Connect the power cord of the recorder to a wall outletConnecting to cable TV signal This set-up will allow you toYou will need to Component Output When the satellite system has audio/video outputs Connecting to a satellite systemConnecting the IR control cable Signal sensor of the set top boxTransmitter About Hdmitm Connecting to a TV with the Hdmi terminalAudio setting for the Hdmi connection Component video outputs/inputs Connecting to aTV equipped with component video inputsDigital audio input Connecting to an audio systemPage Basic Setup Turning the power off Basic SetupTurning the power on ON/STANDBY button ON/STANDBY indicatorStartup/finishing closing icons Press Setup Initial settingsFunction Tip on settingIf a message appears Example of the iconLanguage setting Basic Setup Initial settingsPress / to select a language, then press Auto Time and date settingAuto clock setting Press / to select Auto or Manual, then press EnterNo Use Press EnterAuto UsePress / to select Yes, then press Enter Manual clock settingPress / and Adjust / to set the clock After setting all the items, press EnterChannel setting Press / to select Channel setting, then press EnterPress / to select TV or Cable, then press Enter Channel reference Press / to select Auto, then pressAdding or erasing channels Preparation Set top box settingPress , then press Adjust or / to select Off or On PressOff 10Press Setup RCA Set top box brand codeSample of a Guide channel chart from a local TV listing Guide channel settingGuide channel number 33 HBO Press / to select Audio out select, then press Enter Output sound settingPress Setup to display the setup menu Press / to select Picture/Audio settings, then press EnterAnalog 2ch Once the proper setting is selected, pressPress / to select the output sound format BitstreamTV shape setting Press / to select Display settings, then press EnterPress / to select TV shape, then press Press / to select the picture shape When the proper setting is selected, pressRelease TV Code Remote control settingsOperating a TV with the remote control of this recorder Operating your TV with the remote controlJVC Brand code tablePress / to select DR 2 example, then press Enter Setting up the recorder Press SetupPress / to select Operational settings, then press Enter Press / to select IR code, then pressDisabling the remote control for a temporary period Commercial Units Limited Ninety 90 Day Warranty on LaborLimited One 1 Year Warranty on Parts Rental UnitsHow to Obtain Warranty Services Canadian Warranty Information Garantie Canadienne Memo Printed on 70% Recycled Paper