Toshiba RD-XS52SU Preparation of the remote control, Open the cover Insert batteries AAA size

Page 18

Introduction

Preparation of the remote control

1 Open the cover.

2 Insert batteries (AAA size).

Make sure to match the + and – on the batteries to the marks inside the battery compartment.

3 Close the cover.

Caution

•Never throw batteries into a fire.

Notes

•Dispose of batteries in a designated disposal area.

•Attention should be drawn to the environmental aspects of battery disposal.

•Do not mix different battery types or combine used batteries with new ones.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.

•If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to prevent battery acid from leaking into the battery compartment.

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

30° 30°

Within about 7 m (23 ft)

OPEN/CLOSE

	TV
TV /VIDEO	CH	VOLUME	CH
HDD	TIMESLIP		DVD
		INSTANT REPLAY INSTANT SKIP
	EASY
	NAVI
	VCR Plus+	REC MENU
EXTEND			CONTENT MENU
			S
			KIP

Distance : About 7 m (23 ft) from the front of the remote sensor

Angle : About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the recorder to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the recorder via the remote control.

Notes

•Direct the remote control at the remote sensor of the recorder.

•Do not drop or give the remote control a shock.

•Do not leave the remote control near an extremely hot or humid place.

•Do not spill water or put anything wet on the remote control.

•Do not disassemble the remote control.

18

Image 18

Contents RD-XS52SU RD-XS52SC RD-KX50SU See service procedure This HDD/DVD video recorder employs a Laser SystemMay result in hazardous radiation exposure Location of the required label Important Safety Instructions Additional Safety Instructions Precautions When not in useIntroduction Power Outage ExemptionsWait Introduction PrecautionsDo not use the unit when moisture condensation may occur Moisture condensation occurs during the following casesConnections Video/Audio cable IR control cable Installation procedureAccessories Remote control Batteries AAA x Registration cardAbout this product Choosing a disc Using different disc types for different purposesFor recording / playback Disc Mark Specification Remarks DVD-RAM discs for your personal libraryFor playback only Disc Mark Specification Remarks DiscIntroduction Choosing a disc To protect recorded contentsOn DVD-RAM discs DVD-RAM discs with cartridges are recommended for recordingOn DVD-R discs Marks on DVD video discsOn handling discs Structure of disc contentsOn cleaning discs On storing discsTable of Contents Open the cover Insert batteries AAA size Preparation of the remote controlOperating with the remote control Close the coverConnection procedure When you connect a TV equipped with audio/ video inputsWhen you connect an audio system Connecting an antenna and TV ConnectionsConnect the power cord of the recorder to a wall outlet Connect to a TV equiped with audio/video inputsConnecting to cable TV signal This set-up will allow you toYou will need to Component Output Connecting to a satellite system When the satellite system has audio/video outputsConnecting the IR control cable Signal sensor of the set top boxTransmitter Connecting to a TV with the Hdmi terminal About HdmitmAudio setting for the Hdmi connection Connecting to aTV equipped with component video inputs Component video outputs/inputsConnecting to an audio system Digital audio inputPage Basic Setup ON/STANDBY button ON/STANDBY indicator Basic SetupTurning the power on Turning the power offStartup/finishing closing icons Initial settings Press SetupExample of the icon Tip on settingIf a message appears FunctionLanguage setting Basic Setup Initial settingsPress / to select a language, then press Press / to select Auto or Manual, then press Enter Time and date settingAuto clock setting AutoUse Press EnterAuto No UseAfter setting all the items, press Enter Manual clock settingPress / and Adjust / to set the clock Press / to select Yes, then press EnterChannel setting Press / to select Channel setting, then press EnterPress / to select TV or Cable, then press Enter Channel reference Press / to select Auto, then pressAdding or erasing channels Set top box setting PreparationPress , then press Adjust or / to select Off or On PressOff 10Press Setup Set top box brand code RCAGuide channel setting Sample of a Guide channel chart from a local TV listingGuide channel number 33 HBO Press / to select Picture/Audio settings, then press Enter Output sound settingPress Setup to display the setup menu Press / to select Audio out select, then press EnterBitstream Once the proper setting is selected, pressPress / to select the output sound format Analog 2chTV shape setting Press / to select Display settings, then press EnterPress / to select TV shape, then press When the proper setting is selected, press Press / to select the picture shapeOperating your TV with the remote control Remote control settingsOperating a TV with the remote control of this recorder Release TV CodeBrand code table JVCPress / to select IR code, then press Setting up the recorder Press SetupPress / to select Operational settings, then press Enter Press / to select DR 2 example, then press EnterDisabling the remote control for a temporary period Rental Units Limited Ninety 90 Day Warranty on LaborLimited One 1 Year Warranty on Parts Commercial UnitsHow to Obtain Warranty Services Canadian Warranty Information Garantie Canadienne Memo Printed on 70% Recycled Paper