Toshiba 27A62 Troubleshooting, Problem Solution, For several hours before turning it on again

Appendix

Troubleshooting

Before calling a service technician, please check the following table for a possible cause of the problem and some solutions.

Problem	Solution
TV will not turn on	• Make sure the power cord is plugged in, then press POWER.
	• The remote control batteries may be dead. Replace the batteries.
No picture, no sound	• Check the antenna/cable connections.
No sound, picture OK	• The sound may be muted. Press VOLUME.
	• The station may have broadcast difficulties. Try another channel.
Poor sound, picture OK	• The station may have broadcast difficulties. Try another channel.
Poor picture, sound OK	• Check the antenna connections.
	• The station may have broadcast difficulties. Try another channel.
	• Adjust the PICTURE menu.

Poor reception of broadcast channels

Cannot receive above channel 13

Unable to select a certain channel

Cannot access signal input sources (Video1, Video2, Video3 and ColorStream) and/or Channels 3 and 4

•The station may have broadcast difficulties. Try another channel.

•Check the antenna connections.

•If you are using a VCR, make sure the TV/VCR button is set correctly.

•Make sure TV/CABLE is set to CABLE mode.

•The channel may be blocked by the V-Chip feature or CH LOCK feature, or erased with the add/erase feature.

•Check the VIDEO LOCK feature.

Appendix

Multiple images	• The station may have broadcast difficulties. Try another channel.
	• Use a highly directional outdoor antenna.
Poor color or no color	• The station may have broadcast difficulties. Try another channel.
	• Adjust the TINT and/or COLOR in the PICTURE menu.
	• If you change the direction of the TV while it is turned on, the picture
	could suffer from color shading. If so, turn off the TV and allow it to cool
	for several hours before turning it on again.
No stereo or SAP sound from a	• Make sure the MTS feature is set properly.
known MTS broadcast

The V-Chip PIN code does not work (U.S. V-Chip • Change or reset your PIN code (page 17 and 18). system only)

The remote control does not operate	• Make sure the TV/VCR/CABLE mode is set properly.
	• Remove all obstruction between the remote control and the remote
	control sensor.
	• The remote control batteries may be dead. Replace the batteries.

30

3L51501C/E P25-BACK 30 4/6/2002, 12:45