Sony TC-TX1, SA-N11, HCD-T1 manual CD Player, Playing a CD normal play

Chapter 2:

the CD Player

Playing a CD (normal play)

Playing Tracks in Random Order (shuffle play)

Playing Tracks in the Desired Order (programme play)

Playing Tracks Repeatedly (repeat play)

Playing a CD (normal play)

You can play CDs in four modes: normal, shuffle, programme and repeat. The mode determines which tracks (songs) to play, in which order and whether or not they will repeat.

Also, you can play 12 cm and 8 cm CDs. When you play an 8-cm CD, place it without an adaptor on the inner circle of the disc tray.

Before you play the CD, decrease the sound level by pressing VOL –. This will prevent damage to the speakers.

Tuner CD player	p
	2
	3
1	4

1 Press POWER.

2 Press 6(open/close) and place a CD on the CD tray.

with the label side up

3 Press ^(play) (or ( on the remote). The disc tray closes and the first track starts playing.

1

0 0 3

4 Press VOL + or – to adjust the sound level.

To find the beginning of a track – Automatic Music Sensor (AMS)

You can locate the beginning of a track while the track is playing or while it is in pause mode.

To locate the beginning of the current or preceding track, press =0(or =on the remote) until you find the desired track.

To locate the beginning of the succeeding track, press )+(or +on the remote) until you find the desired track.

To find a point in a track

You can find a particular point in a track while playing or pausing a CD. Use the buttons on the player to operate this feature. This operation is not possible with the remote.

To Search	Operation
Forward while	Hold down )+
listening	and release it at the
	desired point.
Backwards	Hold down =0
while listening	and release it at the
	desired point.
Quickly	Hold down )+ or
without	=0 during pause
listening while	and release it at the
checking the	disired point.
playing time in
the display

Note

If the CD reaches the end while you are searching quickly without listening, "OVER"appears in the display. Press =0 (=on the remote) to go back.

To check the total number of tracks and total playing time

Press DISPLAY on the remote while the player is in stop mode.

The indications appear for a few seconds.

Total number
of tracks	1	2
Total playing	5 4	0 5
time

GB

7

To

Stop play

Pause

Remove the CD

* Remote

Press

p

^(or P*)

To resume play, press here again.

6

To check the remaining time

Press DISPLAY on the remote repeatedly while playing a CD.

Each time you press DISPLAY, the display changes as follows.

One Touch Play feature

Press ^ (or (on the remote) when the power is off or you are listening to another source.

As long as a CD is in the player, you will be able to listen to the CD without pressing any other buttons.

Current track number and Z playing time

v

Current track number and remaining time on the track

v

Remaining time on the CD

Chapter 2: the CD Player