RCA RCU1000B warranty Setup Button

Page 6

RCU1000B_IB.qxd 10/9/01 11:09 AM Page 6

Setup Button

The Setup key is to the lower right of the LCD. To enter the Setup Mode, press and hold the SETUP key. Successive presses of the SETUP key steps you through all the available setup routines. These are:

1. Code Setup Mode?

2. Code Search Mode?

3. Key Labels Mode?

4. Setup a Macro?

5. Delete a Macro?

6. Setup a Timer?

7. Delete a Timer?

8. Learn IR Mode?

9. Delete IR Mode?

10. Delete IR ALL?

11. Set More Options?

12. Reset All?

13. Exit Setup

NOTE: If no Macro is set then “Delete a Macro?” is not offered. If no Timer is set then “Delete a Timer?” is not offered. If nothing has been Learned then “Delete IR Mode?” and “Delete IR ALL?” are not offered.

Pressing Up or Down (arrows) on the LCD also steps through these Setup screens in forward and reverse directions. To exit Setup, press the SETUP key repeatedly, or UP or DOWN on the LCD repeatedly, until the LCD displays “Exit Setup.” Then press OK on the LCD to return to normal operation. Exit from Setup occurs automatically after 60 seconds if no key is pressed. In this case “Timeout” appears in the display for 3 seconds prior to returning to normal operation. Any unconfirmed changes will not be saved.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Touchscreen Table Of Contents Battery Installation To install the batteriesRCU1000B Glossary Of Terms LCDTvvcr Setup Button To delete stored learned commands under a device To search for a code instead of using the code library listTo learn a command Quick Reference GuideTo exit setup while in setup mode To delete all stored learned commandsTo set a timer event To program a macroDirect Code Entry To set the LCD on timeTo set the light on time Code Search Code Search Notes Code IdentificationAuto Search TV Code List 003, 004, 009, 022VCR Code List WardsDVD Code List DVDSatellite Code List Cable Code ListAudio Component Code List Audio Receiver TunerKey Label Mode Setting Up An Event Timer Deleting An Event Timer Learn IR ModeTips On Learning To Learn Commands Learned Key Reference To Delete a Stored Learned Command To Delete ALL Stored Learned CommandsDisplays PressDigit For Delay? To Program a MacroReset All Exit SetupTo Delete a Macro Setting More Options To Set The Time and Day for Normal LCD DisplayTo Set Keypress Beep on or OFF To Set LCD Light On-Time VCR Record RCA All Power Off FeatureVCR/DVD Punch-Through General NotesTroubleshooting Limited 90 Day WarrantyHelpline Inside Card RCU1000B Product Registration Card
Top Page Image Contents