Sony NSX-A707 manual Engl/Sh

Page 2

/ v \ I DO NOT OPENI / \ EE#+!

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.”

Owner’s record

For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact yourAiwa dealer in case of difficulty.

Model No.

Serial No. (Lot No.)

CX-NA707

SX-NA702

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly foIlowed, as well as the safety suggestions below.

Installation

1Water and moisture — Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat — Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 “F)or greater than 35°C (95°F).

3Mounting surface — Place the unit on a flat, even surface.

4 Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight rack

where ventilation may be impeded.

5Objects and liquid entry — Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands — When placed or mounted on a stand or cart, the unit should be moved with care.

Quick stops, excessive force, and

uneven surfaces may cause the m A-s3 unit or cart to overturn or fall.

7Condensation — Moisture may form on the CD pickup lens when:

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8Wall or ceiling mounting —The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.

Electric Power

1Power sources — Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.

2Polarization — As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily inserf into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cords should be firmly secured to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power outlet.

-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock,

I ENGL/SH

Image 2
Contents Tm3iE Digital AudioENGL/SH Basic Operations Continuous Radio ReceptionTape CD Playing Basic Operations Programmed~ English Connect the AC cord to an AC outlet Shift FunctionScoring BBE Bass Shift VolumeVOIL.UIME BassEnglish Turn Multi JOG to select the desired rhythm patternMulti JO Rhythm Press LOW Setting a NEW Equalization Curve ManuallyEqjalization Curve GEQ ShiftSet a new equalization curve with HIGH, LOW, and Multi JOG Within 4 seconds, press EnterMemorizing the NEW DSP Surround Sound Setting a NEW DSP Surround Sound IivianuallyMijlti JOG Delay Effect To search for a station quickly Auto Search Press Tuner Band repeatedly to select the desired bandPress + Down or ~ UP to select a station Flepeat steps 1 ‘f I ti’ ‘,’Inserting Tapes ENGLISH14 Loading Discs Playing DiscsPress numbered buttons 0.9 and +10 to program a track Ll%ss Prgm twice while pressing Shift in stop modePress Disc Direct Play 1-3 to select a disc Insert the tape to be recorded on into deck Press. REV Mode to select the reverse modeInserting Blank Spaces Press REC/REC Mute to start recordingPress Sync DUB once or twice to start recording FYess Tape Deck 1/2 to select deckFYess REC/REC Mute to start recording To stop dubbingPress REC/REC Mute to start recording on the first side Insert the tape into deckPress CD and load the discs Press CD EDIT/CHECK once To stop recordingFor the rest 01 the tracks for Side a Select side !$H!’ Program the tracks for SideConnect your microphones to MIC 1 and MIC 2 jacks To change the audible channel in Multiplex functionTo stop play To add a reservation during playTo check the reserved tracks To skip a current trackPress Clocivtimer ~, then press II SET within 4 seconds Press Down or UP to designate the hour, then press II SETPrepare the source MD Jacks Super Woofers 4 JacksVIDEO/AUX Jacks Line OUT JacksCD Player Section Tuner SectionCassette Deck Section Compact disc player section ~eaker svstem SX-NA702Cassette deck section GeneralPage Eneraia electrica DE Cintas SonidoRecepcion DE LA Radio Reproduction DE DiscosAntes de conectar et cable de alimentacion de CA Compruebe su sistema y Ios accesoriosAltavoces ImportanteCeinecte Ias antenas suministradas Conecte el cable de alimentacion de CA a una toma de CAPara cancelar la demostracion del juego Sistema Super T-BASS Pulse el boton BBEGire Multi JOG para seleccionar ei patron de ritmo deseado Para Seleccionar UN Patron DE RitmoPulse Rhythm Ecualizacion Programada Pulse LOWPara seleccionar la curva de ecualizacion almacenada Pulse Enter antes de aue pasen 4 seaundosPara visualizer el modo DSP Surround actual Para canceiar el modo seleccionadoL+R Modo de entrada Delay Tiempo de retardoRa ajustar el tiempo de retardo Para seleccionar un mod,o de entradaDown O M UP Pulse 44 Down 0- UP para seleccionar una emisoraPara cambiar el intervalo de sintonizacion de AM Sintonizacion Mediante Numero DE PREAJUSTE4 Insercion DE Cintas La reproduction continuara hasta que se pulse Reproduction DE Discos Discos con el Iado de la etiqueta hacia arribaCanciones PrgmInserte la cinta que vaya a grabar en la platina Pulse REV Mode para seleccionar el modo de inversionPulse REC/REC Mute para iniciar la grabacion VIDEO/AUX O MDPulse una o c!os veces Sync DUB para iniciar la N grabaci6n ’ulse Tape Deck 1/2 para seleccionar la platinaPulse @ REC/REC Mute para iniciar la grabacion Tiempo de Ias cintas de casete y tiempo de edition Inserte la cinta en la platinaCheck Pulse REC/RIEC Mute para iniciar la grabaci6n Pulse Disc Direct Play 2, y Iuego pulse +10 y OVOZ/MULTIPLEX Conecte sus microfonos a Ias tomas MIC 1 y MICPulse 4 para iniciar la reproduction Repita el paso 3 para reservar otras cancionesPara visualizer la hors actual Para cancelar el temporizador para dormirIuego pulse II SET Si parpadea la visualization del relojHaber ajustado el volulmeny el tono SETPrepare la fuente de sonido Preparaci&lTomas VIDEO/AUX Tomas PARA’ Altavoces DE Sonido AmbientalConexion DE UNA Antena Exterior Tomas MDGeneralidades Derechos DE Autor Seccion del sintonizador de AMDel amplificador Potenciade salida Page Refer Servicing To Qualified No USER-SERVICEABLE Parts InsideService Personnel Reception Radio PreparationsSON Lecture IDE CAS!5ETTESStereo Contr61er la chaine et Ies accessoiresSpeakers L Nominalecorresponda celle du secteur localElrancher Ie cordon secteur a une prise de courant Function PresetConnecter Ies antennes fournies Marque des points Volume Systeme Super T-13ASSAppuyer sur Rhythm Appuyer sur High ’EGALISATION ProgrammedAppuyer sur LOW Dans Ies uuatre secol~, tourner Multi JCGRegler une nouvelle courbe d’egalisation avec Selection D’UN Mode Surround DSP ProgrammeMemorisation DES Nouvelles Courbes D’EGALISATION Dans Ies uuatre secondes, appuyer sur EnterDans Ies quatre secondes, appuyer sur Enter Multi JOG Delay Effect SurroundReglage Manuel D’UN Nouveau SON Surround DSP ~L+RQuand une emission FM stereo presente des parasites FM AMAppuyer sur + Down ou UP pour Selectionner une station Suppression d’une station rnemorisee Accord SUR UNE Station MemoriseeRepeter Ies etapes 1 et Appuyer sur Pour demarrer la lecture Pour selectionner un mode d’inversion platineREV Mode Pour demarrer la lecture quand I’alimentation est toupeeAu sujet des cassettes Pour Iire un ou deux disaues, mettre Ies disques sur Ies Selection d’une plage avec la telecommandeChangement de disques pendant la lecture Pour arrt?derla lecture, appuyer surPlay 1-3 pour Selectionner Un disque AppuyerDisc Direct Preparation Appuyer sur REV Mode pour selectionner Ie mode d’inversionInsertion D’ESPACES Blancs Inserer la cassette a enregistrer clans la platinePour arr&er la duplication Appuyer sur Tape Deck 1/2 pour selectionner la platineAppuyer sur O REC/REC Mute pour demarrer l’enregistrement Pour arr&er I’enregistrement Inserer la cassette clans la platineAppuyer une fois sur CD EDIT/CHECK Du montageFace Repeter ’etape 5 pcmr Ie resteLa face B, puis programmer Ies plages pour cette Appuyer sur lREC/REC Mute pour d6marrer ’enregistrementllQuand on n’utilise pas Ies microphones Microphones recommandesFonctions Vocal FADER/MULTIPLEX @ Vocal FaderPour ajouter une reservation pendant la lecture ShiftRep6ter I’etape 3 pour reserver d’autres plages Quand on utilise la teiecommande Appuyer sur + Down ou B UP pow Preparer la sourceMettre I’appareil connecte en lecture IONNEXION thmiE Antenne ExterieureArmuver sur VIDEO/AUX ou MD Partie Tuner Nettoyage des t&es et des chemins de bandeLe son ne sort que par une enceinte Droits D’AUTEUR Page Page Page Timer 81SLEEP Clock CLOCK7TIMEROvolume @ Power