Clifford 570.4X Full Silent Arm Protection, Sensor Warn-away Messages, Full Trigger Messages

Page 34

SENSOR WARN

Full Silent Arm Protection

Sensor Warn-away, Sensor Full Trigger and Point of Entry activations will only send messages to the remote, with parking light ﬂash and siren outputs defeated.

Sensor Warn-away Messages

When the remote receives a Sensor Warn-away message it emits 10 beeps (if on) and displays a sensor zone speciﬁc text for 30 seconds. Warn-away messages cannot be reviewed or displayed in reports.

Full Trigger Messages

A Full Trigger message generates a Full Trigger output of siren tones and zone speciﬁc TRIGGER text followed by an alert that consists of 1 long beep per minute for 10 minutes.

To stop the output and alert, press a command button to perform a command, or Press the button.

Emergency Override

The following procedure disarms the system when a programmed re- mote is not available. Number of presses__________

1.Turn the ignition On.

2.Press the control button on the Control Center the correct number of times (the default is 1 press).

3.After a few seconds the siren output ceases and the system is disarmed.

Feature Details

Note As a precaution, if programmed for Passive Arming or Auto re-arming the system should be placed into Valet Mode until a remote is available .

© 2011 Directed Electronics. All rights reserved.

31

Image 34

Contents Page Congratulations What you get Your Warranty Replacement remote controls Government Regulations and Safety informationImportant information Contents Page Page Charging the remote control Getting StartedCan be located through the table of contents Keys to using this manualAt a Glance Responder LC 2-Way Function buttonControl Center At aStatus Screen Icons Table below describes all the status screen iconsRemote Start Zone Status Feature menus Commands and Conﬁrmations Using your SystemPerforming Commands Responder LC Command table Fault Condition AlertsDirected Electronics. All rights reserved Arm Basic Commands Direct AccessDisarm AUX/Trunk Remote StartSilent Disarm Advanced Commands LevelSilent Arm Press and release the button 1 timeTemp Request Runtime ResetIf set to display runtime Commands Press and hold the buttonRemote Valet Sensor BypassPress and release the button 2 times ﬁrm and the Remote start status icons update Commands Timer StartRuntime Remaining Car ﬁnder Sensor Silent ArmPress and release the button 3 times Alarm Report Smart StartDefogger Full Silent ArmPress and release the button 4 times Navigating menus and options Access menu itemsResponder LC Conﬁguration Button operationMode Setup Remote menu Keypad LockMain Menu Button followed byAlert Remote Start InfoScreen Color Runtime AlertCar Temp UnitSystem Type Sensor AdjustButton Beep Clock SetPair Remote MenuDemo mode Power OffNormal Arm Protection Alarm FeaturesSensor Silent Arm protection Full Trigger Messages Full Silent Arm ProtectionSensor Warn-away Messages Emergency OverrideTrigger Zone Fault Report Alarm Report when disarmingAlarm Report when requested Nuisance Prevention NPCPit Stop Mode Remote Start FeaturesKey Takeover Disabling Remote Start Remote Start Safe-lockAdvanced Start Timer Start operation Temperature ReportingSmart Start operation Remote Start Time-out Alert Manual Transmission Start MTS modeStart the engine and the text and tones play as an alert Turbo Timer Mode Remote Start Error Auto Re-arming Remote and System OperationsPassive Arming Onetime BypassAutomatic Remote Updates Valet ModePower Save Rapid ResumeOut of Range Feature not AvailableNo Remote Output Way Companion Remote Control WayButton Auto Lock Using the 1 way companion remoteAccessing Commands Car SelectRemote Features menu ProgrammingPolarity, replace the old battery Battery Information 1-WayRemote control housing Tray while gently prying the traySystem Expansion Options Driver door priority unlocking Auxiliary ChannelsBattery Information Responder LC Low BatteryBattery Life Battery Disposal Glossary of Terms Document Terminology Control ModulePatent Information Remote Controls Government RegulationsSafety Control CenterRemote Start Capable InstallationManual Transmission Vehicles Operation of the Remote Start Module if the Vehicle Starts Interference Upgrades and BatteriesWater/Heat Resistance Limited lifetime consumer warranty Directed Electronics. All rights reserved