Clifford 570.4X manual Battery Information 1-Way, Tray while gently prying the tray

Page 49

Battery Information (1-Way)

The 1way companion remote is powered by one 3V coin cell lithium battery (PN CR-2032) that will last approximately one year under normal use.

Battery Replacement

 

1

Side View

2

Rear View

1. Using a small flat narrow object,

 

 

push latch down towards battery

 

 

 

 

 

 

 

 

tray while gently prying the tray

 

 

 

 

outwards from both ends until re-

 

 

 

 

leased. Remove the tray from the

 

Latch

 

 

remote control housing.

 

Battery

 

+

 

Tray

 

 

2. While observing the correct

 

 

 

 

polarity, replace the old battery

 

 

 

 

with a new one. Seat battery flush

into tray and slide back into housing until securely latched. The remote control is now ready for use.

46

© 2011 Directed Electronics. All rights reserved.

Image 49
Contents Page Congratulations What you get Your Warranty Replacement remote controls Government Regulations and Safety informationImportant information Contents Page Page Getting Started Charging the remote controlCan be located through the table of contents Keys to using this manualAt a Glance Function button Responder LC 2-WayAt a Control CenterTable below describes all the status screen icons Status Screen IconsRemote Start Zone Status Feature menus Commands and Confirmations Using your SystemPerforming Commands Fault Condition Alerts Responder LC Command tableDirected Electronics. All rights reserved Arm Basic Commands Direct AccessDisarm Remote Start AUX/TrunkSilent Arm Advanced Commands LevelSilent Disarm Press and release the button 1 timeIf set to display runtime Commands Runtime ResetTemp Request Press and hold the buttonRemote Valet Sensor BypassPress and release the button 2 times firm and the Remote start status icons update Commands Timer StartRuntime Remaining Car finder Sensor Silent ArmPress and release the button 3 times Smart Start Alarm ReportDefogger Full Silent ArmPress and release the button 4 times Responder LC Configuration Access menu itemsNavigating menus and options Button operationMain Menu Setup Remote menu Keypad LockMode Button followed byRemote Start Info AlertCar Runtime AlertScreen Color Temp UnitButton Beep Sensor AdjustSystem Type Clock SetMenu Pair RemotePower Off Demo modeNormal Arm Protection Alarm FeaturesSensor Silent Arm protection Sensor Warn-away Messages Full Silent Arm ProtectionFull Trigger Messages Emergency OverrideAlarm Report when disarming Trigger Zone Fault ReportNuisance Prevention NPC Alarm Report when requestedPit Stop Mode Remote Start FeaturesKey Takeover Disabling Remote Start Remote Start Safe-lockAdvanced Start Timer Start operation Temperature ReportingSmart Start operation Remote Start Time-out Alert Manual Transmission Start MTS modeStart the engine and the text and tones play as an alert Turbo Timer Mode Remote Start Error Passive Arming Remote and System OperationsAuto Re-arming Onetime BypassPower Save Valet ModeAutomatic Remote Updates Rapid ResumeOut of Range Feature not AvailableNo Remote Output Way Way Companion Remote ControlAccessing Commands Using the 1 way companion remoteButton Auto Lock Car SelectProgramming Remote Features menuRemote control housing Battery Information 1-WayPolarity, replace the old battery Tray while gently prying the traySystem Expansion Options Auxiliary Channels Driver door priority unlockingLow Battery Battery Information Responder LCBattery Life Battery Disposal Document Terminology Control Module Glossary of TermsPatent Information Government Regulations Remote ControlsControl Center SafetyRemote Start Capable InstallationManual Transmission Vehicles Operation of the Remote Start Module if the Vehicle Starts Interference Upgrades and BatteriesWater/Heat Resistance Limited lifetime consumer warranty Directed Electronics. All rights reserved