Clifford 570.4X manual Remote Start Error

Page 42

Remote Start Error

For user safety, the system must be properly conﬁgured or remote start will not activate. Refer to the table below for the screens and parking light ﬂashes that will identify the conﬁguration issue and resolution.

Flashes *	Possible Fault	Solution
5	Brake on	Release foot brake

6	Hood open	Close hood

7	After performing Remote Start	Enable MTS mode
	command - MTS not enabled
	After performing Timer Start or	Check all Solutions
	Smart Start command

8	Toggle Switch off	Turn switch on

None	Alarm is triggered	Disarm or reset alarm

* Refers to the number of parking light ﬂashes.

Feature Details

© 2011 Directed Electronics. All rights reserved.

39

Image 42

Contents Page Congratulations What you get Government Regulations and Safety information Your Warranty Replacement remote controlsImportant information Contents Page Page Charging the remote control Getting StartedKeys to using this manual Can be located through the table of contentsAt a Glance Responder LC 2-Way Function buttonControl Center At aStatus Screen Icons Table below describes all the status screen iconsRemote Start Zone Status Feature menus Using your System Commands and ConﬁrmationsPerforming Commands Responder LC Command table Fault Condition AlertsDirected Electronics. All rights reserved Basic Commands Direct Access ArmDisarm AUX/Trunk Remote StartSilent Disarm Advanced Commands LevelSilent Arm Press and release the button 1 timeTemp Request Runtime ResetIf set to display runtime Commands Press and hold the buttonSensor Bypass Remote ValetPress and release the button 2 times Timer Start ﬁrm and the Remote start status icons update CommandsRuntime Remaining Sensor Silent Arm Car ﬁnderPress and release the button 3 times Alarm Report Smart StartFull Silent Arm DefoggerPress and release the button 4 times Navigating menus and options Access menu itemsResponder LC Conﬁguration Button operationMode Setup Remote menu Keypad LockMain Menu Button followed byAlert Remote Start InfoScreen Color Runtime AlertCar Temp UnitSystem Type Sensor AdjustButton Beep Clock SetPair Remote MenuDemo mode Power OffAlarm Features Normal Arm ProtectionSensor Silent Arm protection Full Trigger Messages Full Silent Arm ProtectionSensor Warn-away Messages Emergency OverrideTrigger Zone Fault Report Alarm Report when disarmingAlarm Report when requested Nuisance Prevention NPCRemote Start Features Pit Stop ModeKey Takeover Remote Start Safe-lock Disabling Remote StartAdvanced Start Temperature Reporting Timer Start operation Smart Start operation Manual Transmission Start MTS mode Remote Start Time-out AlertStart the engine and the text and tones play as an alert Turbo Timer Mode Remote Start Error Auto Re-arming Remote and System OperationsPassive Arming Onetime BypassAutomatic Remote Updates Valet ModePower Save Rapid ResumeFeature not Available Out of RangeNo Remote Output Way Companion Remote Control WayButton Auto Lock Using the 1 way companion remoteAccessing Commands Car SelectRemote Features menu ProgrammingPolarity, replace the old battery Battery Information 1-WayRemote control housing Tray while gently prying the traySystem Expansion Options Driver door priority unlocking Auxiliary ChannelsBattery Information Responder LC Low BatteryBattery Life Battery Disposal Glossary of Terms Document Terminology Control ModulePatent Information Remote Controls Government RegulationsSafety Control CenterInstallation Remote Start CapableManual Transmission Vehicles Operation of the Remote Start Module if the Vehicle Starts Upgrades and Batteries InterferenceWater/Heat Resistance Limited lifetime consumer warranty Directed Electronics. All rights reserved