Clifford 570.4X manual Safety, Control Center

Page 58

Control Center

To satisfy FCC RF exposure compliance requirements, the device and its an- tenna must maintain a separation distance of 20 cm or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance.

This device complies with the Industry Canada Radio Standards Speciﬁcation RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device.

WARNING! Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate this de- vice.

Safety

© 2011 Directed Electronics. All rights reserved.

55

Image 58

Contents Page Congratulations What you get Your Warranty Replacement remote controls Government Regulations and Safety informationImportant information Contents Page Page Charging the remote control Getting StartedCan be located through the table of contents Keys to using this manualAt a Glance Responder LC 2-Way Function buttonControl Center At aStatus Screen Icons Table below describes all the status screen iconsRemote Start Zone Status Feature menus Commands and Conﬁrmations Using your SystemPerforming Commands Responder LC Command table Fault Condition AlertsDirected Electronics. All rights reserved Arm Basic Commands Direct AccessDisarm AUX/Trunk Remote StartSilent Disarm Advanced Commands LevelSilent Arm Press and release the button 1 timeTemp Request Runtime ResetIf set to display runtime Commands Press and hold the buttonRemote Valet Sensor BypassPress and release the button 2 times ﬁrm and the Remote start status icons update Commands Timer StartRuntime Remaining Car ﬁnder Sensor Silent ArmPress and release the button 3 times Alarm Report Smart StartDefogger Full Silent ArmPress and release the button 4 times Navigating menus and options Access menu itemsResponder LC Conﬁguration Button operationMode Setup Remote menu Keypad LockMain Menu Button followed byAlert Remote Start InfoScreen Color Runtime AlertCar Temp UnitSystem Type Sensor AdjustButton Beep Clock SetPair Remote MenuDemo mode Power OffNormal Arm Protection Alarm FeaturesSensor Silent Arm protection Full Trigger Messages Full Silent Arm ProtectionSensor Warn-away Messages Emergency OverrideTrigger Zone Fault Report Alarm Report when disarmingAlarm Report when requested Nuisance Prevention NPCPit Stop Mode Remote Start FeaturesKey Takeover Disabling Remote Start Remote Start Safe-lockAdvanced Start Timer Start operation Temperature ReportingSmart Start operation Remote Start Time-out Alert Manual Transmission Start MTS modeStart the engine and the text and tones play as an alert Turbo Timer Mode Remote Start Error Auto Re-arming Remote and System OperationsPassive Arming Onetime BypassAutomatic Remote Updates Valet ModePower Save Rapid ResumeOut of Range Feature not AvailableNo Remote Output Way Companion Remote Control WayButton Auto Lock Using the 1 way companion remoteAccessing Commands Car SelectRemote Features menu ProgrammingPolarity, replace the old battery Battery Information 1-WayRemote control housing Tray while gently prying the traySystem Expansion Options Driver door priority unlocking Auxiliary ChannelsBattery Information Responder LC Low BatteryBattery Life Battery Disposal Glossary of Terms Document Terminology Control ModulePatent Information Remote Controls Government RegulationsSafety Control CenterRemote Start Capable InstallationManual Transmission Vehicles Operation of the Remote Start Module if the Vehicle Starts Interference Upgrades and BatteriesWater/Heat Resistance Limited lifetime consumer warranty Directed Electronics. All rights reserved