Programming
To enter; hold the 
button for 8 seconds, the remote emits one long beep and turns the LED on, the programming main menu has been accessed.
To exit; press and release the 
button to go back and repeat to exit. 1 short and 1 long beep is emitted for each step back, the LED turns off when programming is exited.
Sensor Adjust
The 
button is used for sensor adjustment, to avoid unintended alarm triggers, it is recommenced that an authorized Directed dealer perform all sensor adjustments.
Remote Features menu
Press and release the 
button, 2 LED flashes and beeps indi- cate the remote features menu is accessed and can be set. Press buttons indicated below, 1beep and flash turns the feature on, 2 beeps and flashes turns the feature off.
ssAutolock feature: Press 
to turn on/off.
ss Remote Beeps: Press 
to turn on/off.
ss Car 2 feature: Press 
to turn on/off.
Remote Learning
Press the 
button,3 LED flashes and beeps indicates the remote is ready to program to the system.
Per the instruction in “Pair Remote:” on page 28 under the Main Menu section of this guide, following step 4 of Prepare the vehicle system to be Paired with a new remote. Press and
hold the 
button, the siren emits one long chirp to confirm the remote has been learned.
1-Way
© 2011 Directed Electronics. All rights reserved. | 45 |