Clifford 570.4X manual Turbo Timer Mode

Page 41

6.Exit the vehicle, close all the doors and arm the system.

7.The engine turns off and after a few seconds, the REMOTE START OFF message plays to conﬁrm. If the door is opened in Step 3 then the engine continues to run.

Turbo Timer Mode

The system keeps the engine running for the Turbo Timer runtime and can be activated by remote control or optional dash mounted activa- tion button.

1.With the engine running, set the parking brake.

2.Press the optional dash mounted activation button or perform the Timer Mode command.

3.The parking lights turn on and the remote start activates the igni- tion outputs. The REMOTE START ON text and beeps play to con- ﬁrm.

4.Turn Off and remove the key from the ignition switch, the engine remains running.

5.Exit the vehicle, close all the doors and arm the system.

6.The engine runs for the Turbo Mode runtime.

Note Turbo Timer must be turned on by an authorized Directed dealer.

38	© 2011 Directed Electronics. All rights reserved.

Image 41

Contents Page Congratulations What you get Important information Government Regulations and Safety informationYour Warranty Replacement remote controls Contents Page Page Getting Started Charging the remote controlAt a Glance Keys to using this manualCan be located through the table of contents Function button Responder LC 2-WayAt a Control CenterTable below describes all the status screen icons Status Screen IconsRemote Start Zone Status Feature menus Performing Commands Using your SystemCommands and Conﬁrmations Fault Condition Alerts Responder LC Command tableDirected Electronics. All rights reserved Disarm Basic Commands Direct AccessArm Remote Start AUX/TrunkSilent Arm Advanced Commands LevelSilent Disarm Press and release the button 1 timeIf set to display runtime Commands Runtime ResetTemp Request Press and hold the buttonPress and release the button 2 times Sensor BypassRemote Valet Runtime Remaining Timer Startﬁrm and the Remote start status icons update Commands Press and release the button 3 times Sensor Silent ArmCar ﬁnder Smart Start Alarm ReportPress and release the button 4 times Full Silent ArmDefogger Responder LC Conﬁguration Access menu itemsNavigating menus and options Button operationMain Menu Setup Remote menu Keypad LockMode Button followed byRemote Start Info AlertCar Runtime AlertScreen Color Temp UnitButton Beep Sensor AdjustSystem Type Clock SetMenu Pair RemotePower Off Demo modeSensor Silent Arm protection Alarm FeaturesNormal Arm Protection Sensor Warn-away Messages Full Silent Arm ProtectionFull Trigger Messages Emergency OverrideAlarm Report when disarming Trigger Zone Fault ReportNuisance Prevention NPC Alarm Report when requestedKey Takeover Remote Start FeaturesPit Stop Mode Advanced Start Remote Start Safe-lockDisabling Remote Start Smart Start operation Temperature ReportingTimer Start operation Start the engine and the text and tones play as an alert Manual Transmission Start MTS modeRemote Start Time-out Alert Turbo Timer Mode Remote Start Error Passive Arming Remote and System OperationsAuto Re-arming Onetime BypassPower Save Valet ModeAutomatic Remote Updates Rapid ResumeNo Remote Output Feature not AvailableOut of Range Way Way Companion Remote ControlAccessing Commands Using the 1 way companion remoteButton Auto Lock Car SelectProgramming Remote Features menuRemote control housing Battery Information 1-WayPolarity, replace the old battery Tray while gently prying the traySystem Expansion Options Auxiliary Channels Driver door priority unlockingLow Battery Battery Information Responder LCBattery Life Battery Disposal Document Terminology Control Module Glossary of TermsPatent Information Government Regulations Remote ControlsControl Center SafetyManual Transmission Vehicles InstallationRemote Start Capable Operation of the Remote Start Module if the Vehicle Starts Water/Heat Resistance Upgrades and BatteriesInterference Limited lifetime consumer warranty Directed Electronics. All rights reserved