Clifford 570.4X manual Trigger Zone Fault Report, Alarm Report when disarming

Page 35
ALARM REPORT

Trigger Zone Fault Report

When armed by remote command the system runs a status check of the alarm trigger zones. Faulty zones (usually caused by dome light delay or open trunk) are bypassed and reported via the control center LED and remote, while all other trigger zones remain active and are monitored to protect the vehicle. Should a faulty zone self correct (dome light turns off) it becomes active and is then monitored normally.

The siren chirps once again a few seconds following the arming chirps as an audible alert, the control center LED flashes in groups to indicate the zone number. The remote will emit a single fault tone and play zone specific text that identifies the faulty zones.

Alarm Report when disarming

The most recent alarm triggers (if any) are reported when the alarm is disarmed via the remote control, siren chirps, parking light and control center LED flashes. The siren chirps 4 times (or 5 times if NPC On*), the parking lights flash 3 times, and the control center LED flashes in groups to indicate the last two zones that were triggered (see Table

of Zones). The DISARM text is replaced by and text identifying the triggers.

*See “Nuisance Prevention (NPC)” on page 33 for more details.

32

© 2011 Directed Electronics. All rights reserved.

Image 35
Contents Page Congratulations What you get Important information Government Regulations and Safety informationYour Warranty Replacement remote controls Contents Page Page Getting Started Charging the remote controlAt a Glance Keys to using this manualCan be located through the table of contents Function button Responder LC 2-WayAt a Control CenterTable below describes all the status screen icons Status Screen IconsRemote Start Zone Status Feature menus Performing Commands Using your SystemCommands and Confirmations Fault Condition Alerts Responder LC Command tableDirected Electronics. All rights reserved Disarm Basic Commands Direct AccessArm Remote Start AUX/TrunkPress and release the button 1 time Advanced Commands LevelSilent Arm Silent DisarmPress and hold the button Runtime ResetIf set to display runtime Commands Temp RequestPress and release the button 2 times Sensor BypassRemote Valet Runtime Remaining Timer Startfirm and the Remote start status icons update Commands Press and release the button 3 times Sensor Silent ArmCar finder Smart Start Alarm ReportPress and release the button 4 times Full Silent ArmDefogger Button operation Access menu itemsResponder LC Configuration Navigating menus and optionsButton followed by Setup Remote menu Keypad LockMain Menu ModeRemote Start Info AlertTemp Unit Runtime AlertCar Screen ColorClock Set Sensor AdjustButton Beep System TypeMenu Pair RemotePower Off Demo modeSensor Silent Arm protection Alarm FeaturesNormal Arm Protection Emergency Override Full Silent Arm ProtectionSensor Warn-away Messages Full Trigger MessagesAlarm Report when disarming Trigger Zone Fault ReportNuisance Prevention NPC Alarm Report when requestedKey Takeover Remote Start FeaturesPit Stop Mode Advanced Start Remote Start Safe-lockDisabling Remote Start Smart Start operation Temperature ReportingTimer Start operation Start the engine and the text and tones play as an alert Manual Transmission Start MTS modeRemote Start Time-out Alert Turbo Timer Mode Remote Start Error Onetime Bypass Remote and System OperationsPassive Arming Auto Re-armingRapid Resume Valet ModePower Save Automatic Remote UpdatesNo Remote Output Feature not AvailableOut of Range Way Way Companion Remote ControlCar Select Using the 1 way companion remoteAccessing Commands Button Auto LockProgramming Remote Features menuTray while gently prying the tray Battery Information 1-WayRemote control housing Polarity, replace the old batterySystem Expansion Options Auxiliary Channels Driver door priority unlockingLow Battery Battery Information Responder LCBattery Life Battery Disposal Document Terminology Control Module Glossary of TermsPatent Information Government Regulations Remote ControlsControl Center SafetyManual Transmission Vehicles InstallationRemote Start Capable Operation of the Remote Start Module if the Vehicle Starts Water/Heat Resistance Upgrades and BatteriesInterference Limited lifetime consumer warranty Directed Electronics. All rights reserved