Carrier Access AB II manual 560DQDJHPHQW&DEOH, Connecting the PC Directly to the Access Bank

Page 14

1.4 Connecting the PC Directly to the Access Bank II

The RS-232 Management cable (provided) is equipped with a male 26-pin D-type subminiature connector on the end that mates with the secondary RS-232 connector pins of the Management port, and a female 25-pin connector on the DCE end for connection to the RS-232 communications interface of the PC.

D-SUB-26 (male)		DCE-DB-25
SECONDARY	BRAID	(female)

		1 SHIELD			1 SHIELD
		7 GND		GND	7 GND
				GND
				TXD
		14 STXD		TXD	2 TX
		14 STXD		RXD	2 TX
		16 SRXD		RXD	3 RX
		16 SRXD		RTS	3 RX
		19 SRTS		RTS	4 RTS
		19 SRTS		CTS	4 RTS
		13 SCTS		CTS	5CTS
		13 SCTS		DTR	5CTS
		10 SDTR		DTR	20DTR
		10 SDTR		CD	20DTR
		12 SCD		CD	8CD



RS-232 Management Port
on Access Bank II

Local PC with Remote

Monitor Software

560DQDJHPHQW&DEOH

&RPP3RUWRQ

0DQDJHPHQW3&

560DQDJHPHQW 3RUWRQ$FFHVV%DQN,,

To connect a local PC to the Access Bank II using the RS-232 Management Cable:

1.Set the System Configuration Local/Remote DIP switch 1 on the Access Bank II Control Panel to the Remote mode.

1-4

Image 14

Contents Access Bank Page Page Page Access Bank Access Bank Access Bank II SnmpAccess Bank II Sdsl Access Bank II Snmp SdslPage Contents Data Port Setup Getting Started System RequirementsSoftware Overview Software InstallationInstalling Remote Monitor Creating a Shortcut on the DesktopRemote Monitor Connecting the PC Directly to the Access Bank 560DQDJHPHQW&DEOHConnecting a Modem to the Access Bank II for Remote Access WR%0Starting Up Remote Monitor Pull-Down Menus Setting Up Remote Monitor Selecting the Current ProductSetting Up Remote Management Connecting to the Access Bank Click on Connect Now, orSetting Up Remote Monitor Help General Rules and Tips for Using the Remote Monitor Reading and Sending ScreensPage Changing to a New Product Saving ConfigurationsScreen Flagging Loading Configurations MiscellaneousFlagging Changed Screens System SetupSystem Setup Screens Names Screen Problem Reporting Screen System Clock Screen Snmp ScreenConfiguring Network Parameters ColdStart Trap and warmStart Trap Configuring System Group Information Page T1 Setup T1 Setup2 T1 Hardware Setup System Clock SourceT1 Definitions Line Build Out LBO Data Port Setup V.35 Data Port SetupSetting the CTS Control Option Setting the Synchronous Data Rate or Asynchronous Subrate RS-232 Data Port SetupRS-232 Data Port Setup Synchronous Data Rate Option Asynchronous Subrate Options Page Connections Static ConnectionsConnecting Individual Channels Configuring Contiguous Channels Channel TypeChannel/Signal Type Screen Performance Event Log ScreenMessage Event Log Screen 3 T1 History Retrieving Events from the Event LogClearing the Event Log Loss of Received T1 Signal Also called Loss of Carrier DefinitionsSeverely Errored Seconds 5 T1 History Last 24 HoursLoopback Configuration MaintenanceTesting TSI Bert Internal Bert Configuration Loopback Configuration SettingsAnalog Ports Update Interval Update IntervalsFXS Lcfo LCF LEDs System LEDs DIP Switches Definition of V.35 Status LED last LEDDIP Switches